AEG BEB352010M 사용자 설명서 - 페이지 35

{카테고리_이름} AEG BEB352010M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG BEB352010M 40 페이지.

페이지 인쇄

1. Care and Cleaning

Step 1

Fully open the door.

Step 2

Fully press the clamping

levers (A) on the two door

hinges.

Step 3

Close the oven door to the first opening position (approximately 70° angle).

Hold the door at both sides and pull it away from the oven at an upwards an-

gle. Put the door with the outer side down on a soft cloth on a stable surface.

Step 4

Hold the door trim (B) on

the top edge of the door at

the two sides and push in-

wards to release the clip

seal.

Step 5

Pull the door trim to the

front to remove it.

Step 6

Hold the door glass panels

on their top edge one by

one and pull them up out of

the guide.

Step 7

Clean the glass panel with

water and soap. Dry the

glass panel carefully. Do not

clean the glass panels in the

dishwasher.

Step 8

After cleaning, do the

above steps in the opposite

sequence.

Step 9

Install the smaller panel first, then the larger and the door.

Make sure that the glasses are inserted in the correct position otherwise the

surface of the door may overheat.

11.7 How to replace: Lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

Step 1

Turn off the oven. Wait until

the oven is cold.

Before you replace the lamp:

Step 2

Disconnect the oven from

the mains.

ENGLISH

Step 3

Put a cloth on the bottom of

the cavity.