Alinco DR-MD500 사용 설명서 - 페이지 12

{카테고리_이름} Alinco DR-MD500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alinco DR-MD500 20 페이지. Vhf/uhf dual band digital transceiver

The transceiver may be installed in any position in your car, where the

controls and microphone are easily accessible and it does not interfere with

the safe operation of the vehicle. If your vehicle is equipped with air bags,

be certain your transceiver will not interfere with their deployment. If you

are uncertain about where to mount the unit, contact your vehicle's dealer.

Prepare screwdriver to fasten and loosen screws.

Install the mounting bracket in the vehicle using the supplied self-

tapping screws (4pcs) and flat washers (4pcs).

Position the transceiver, then insert and tighten the supplied hexagon

SEMS screws.

Double check that all screws are tightened to prevent vehicle

vibration from loosening the bracket or transceiver.

Car body

Washer (M5)

Tapping screw

(M5x20mm)

Mounting bracket

Caution:

Use only the provided screws

otherwise you risk damaging

the circuit board, components

or fall-off of the unit.

Initial Installation

Determine the appropriate

angle of the transceiver, using

the 3 screw hole positions

on the side of the mounting

bracket.

To remove the transceiver,

unscrew all fixing hardware,

and hold the transceiver

in the way that it won't fall

from bracket.

I n s t a l l m i c h a n g e r u n i t .

Install the mic hanger in the

vehicle using the supplied

self tapping screws (2pcs)

and washers (2pcs).