A+V Link Technologies AVM-6996H-SYS-A1 빠른 설정 매뉴얼 - 페이지 5

{카테고리_이름} A+V Link Technologies AVM-6996H-SYS-A1에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A+V Link Technologies AVM-6996H-SYS-A1 8 페이지. Powerhdlink kit

페이지 인쇄

A+V Link Technologies

Step 6: Connect the TX and RX to the LAN.

Use an Ethernet cable (CAT 5/5e/6) and attach it to the LAN connector on the back of the TX – attach

the other end of the cable to a LAN port. Do the same for the RX.

Step 7: Turn on power switches

Turn on the Power Switches on the rear panels of both RX and TX.

Wait for about 10 seconds.

A red Power Indicator light will illuminate on the front panel of both

the Transmitter and Receiver. The Source LED indicator on the

TX will show which of the available input connectors is currently in

use

Source LED indicators on front panel:

HDMI 1

HDMI connector 1

HDMI 2

HDMI connector 2

HDMI 3

HDMI connector 3

AV 1

CVBS/S-Video

AV 2

YPbPr connectors

In our example we connected the Blu-Ray player to HDMI #3, so

the Source LED indicator "HDMI 3" should illuminate.

4 Video Source Remote Control

With the PowerHDLink system, you can control your video player from the remote location (i.e. where

RX is located), using the Video Player's remote controller (must be Infrared Remote Controller). The

RX is fitted with an IR sensor that receives the signals and sends them over the power lines to the TX,

where the TX re-emits the same IR signals to the video player.

PowerHDLink Quick Setup Guide

Source LED

indicators

Version 1.0

Power LED