Garmin StreetPilot III 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Garmin StreetPilot III에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin StreetPilot III 21 페이지. Portable gps with auto-routing and voice
Garmin StreetPilot III에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (13 페이지), 사양 (2 페이지), 사용 설명서 및 참조 설명서 (6 페이지)

페이지 인쇄

Quick Start

Turning On/Off

Adjusting Backlighting,

Contrast and Volume

IN POINT THREE MILES

TURN RIGHT

When the external speaker is connected, your StreetPilot

III provides audible prompts during route navigation.

These 'spoken' prompts include approaching turn notiﬁ -

cation (direction of turn and distance), off course notiﬁ -

cation, and arrival at destination.

Spoken messages are also provided for poor GPS cover-

age and low battery power.

Automatic voice prompting can be turned off via a

system setup option (but can always be triggered by

pressing the VOL/SPEAK key (see page 40).

Turning the StreetPilot III On and Off

Press and hold the

POWER

key to turn the unit on (a power tone will momentarily sound). The

Welcome Page appears brieﬂ y, followed by the MapSource Copyright Page. Press

the copyright, or wait brieﬂ y until the Safe Driving Warning Message appears. Once again, press

to acknowledge the warning or wait until the Warning Page is replaced by the Map Page. When the

Map Page appears, the unit is ready for operation.

When you are ready to turn the unit off, press and hold the

Adjusting the Backlight, Contrast, and Speaker Volume

The StreetPilot III display and keys can be illumi-

nated for operation at night or in bright sunlight. Back-

light intensity and screen contrast are adjustable. When

operating the StreetPilot III at extreme temperatures,

you may ﬁ nd that minor adjustments are needed to

obtain the clearest screen.

To adjust screen backlighting and contrast:

1. Press the red POWER key momentarily. An on-screen window appears allowing you to adjust the

backlight and contrast levels.

2. Use the ROCKER KEYPAD to adjust the backlight and the contrast to the desired level. (Alterna-

tively, backlighting can be cycled between three settings by repeatedly pressing the red POWER key.)

The backlight and contrast window will disappear after a few seconds of inactivity.

To adjust the external speaker volume:

1. Press and hold the VOL/SPEAK key. A slider adjustment window appears.

2. Adjust the speaker volume by using the ROCKER KEYPAD. The loudest setting is eight, the

softest is one. (Alternatively, volume can be cycled between three settings by repeatedly pressing

VOL/SPEAK.)

to acknowledge

ENTER

POWER

key.