Garmin ZUMO 396 LMT-S Europe 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Garmin ZUMO 396 LMT-S Europe에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin ZUMO 396 LMT-S Europe 32 페이지.
페이지 인쇄
Installation
Mounting your device in a motorcycle
Powered Motorcycle Mount
Garmin
strongly recommends having an experienced installer
®
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
See the Important safety and product information guide in the
product box for product warnings and other important
information.
The device must be mounted in a suitable and secure location
on your motorcycle, based on available power sources and safe
cable routing.
Motorcycle cradle
12 to 24 Vdc system power (red)
NOTE: the red system power cable may include an inline fuse on
some device models. Cables without an inline fuse are protected
internally.
System ground (black)
Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt
around the handlebar
ends through the handlebar base
2
Tighten the nuts to secure the base.
NOTE: the recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket
.
Installation
WARNING
, and thread the
.
NOTE: both 1/4 in. (65 mm) standard and M6 bolts are
included. Match the size of the factory bolts on your clutch-
clamp or brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Power Cables to the Motorcycle Mount
1
Thread the power cable connector
opening in the motorcycle mount.
2
Slide the cable down to the bottom of the opening
the cable back until it is snug.
3
Screw the black screw
hold the cable in place.
4
Thread the weather cap
into the hole.
through the handlebar base, spacers
through the top of the
into the back of the mount
through the top hole and press it
and pull
to
1