Garmin D2 AIR X10 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Garmin D2 AIR X10에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin D2 AIR X10 48 페이지.
페이지 인쇄
Setting the Auto Fly Value
1 Hold
.
2 Select Activities & Apps > FLY.
3 Select the activity settings.
4 Select Auto Fly.
5 Select the auto fly value.
A flying activity starts automatically when your
detected climb rate exceeds this value.
Starting a Flight
1 Press
.
2 Select FLY.
3 Go outside to an area with a clear view of the sky, and
wait while the watch locates satellites.
4 Press
to start the flight timer.
NOTE: Your activity data is recorded only while the
flight timer is running.
5 Start your activity.
6 After you complete your activity, press
.
Viewing Your SpO2 Readings in Flight
The SpO2 readings are intended for backup information
only. Always defer to applicable flight instruments for
primary awareness.
The D2 Air X10 watch has a wrist-based pulse oximeter to
gauge the saturation of oxygen in your blood (SpO2).
Knowing your oxygen saturation can help you determine
how your body is adjusting to high altitudes. As your
altitude increases, the level of oxygen in your blood can
decrease. During a flight, the watch automatically takes
pulse oximeter readings more frequently, so you can
monitor your SpO2 percentage.
TIP: You can improve the accuracy of your SpO2 readings
by turning on all-day acclimation mode in the pulse
oximeter glance settings
Tracking Mode, page
14).
1 Start a FLY activity.
2 Swipe up or down to scroll through the data screens.
Your most recent reading appears as an oxygen
saturation percentage.
NOTE: If you are too active for the watch to determine
your oxygen saturation, dashes appear instead of a
percentage. You should remain stationary for up to 30
seconds while the watch reads your blood oxygen
saturation.
Navigating to the Nearest Airport
1 Hold
.
2 Select
> Nearest.
3 If necessary, go outside to an area with a clear view of
the sky, and wait while the watch locates satellites.
A list of the nearest airports appears.
Flying
, and select
WARNING
(Changing the Pulse Oximeter
4 Select an airport.
5 Press
to start the flight timer.
NOTE: Your activity data is recorded only while the
flight timer is running.
Nearest Airports
Nearest airport identifier
Distance to the nearest airport
Bearing to the nearest airport
Navigating to an Aviation Waypoint by Its Identifier
You can navigate directly to an aviation waypoint by
searching for an alphanumeric identifier.
1 Hold
.
2 Select
> Enter Ident..
3 Enter all or part of the alphanumeric identifier.
4 Press
.
A list of matching waypoints appears.
5 Select the waypoint.
6 Go outside to an area with a clear view of the sky, and
wait while the watch locates satellites.
7 Press
to begin navigation.
Navigating Directly to a Saved Location
Before you can navigate to a saved location, your watch
must locate satellites.
1 Press
.
2 Select Navigate > Saved Locations.
3 Select a location, and select Direct-To.
4 Press
to start the flight timer.
Horizontal Situation Indicator
3