ALISEO VentilClima 010 LCD 2T 매뉴얼 - 페이지 3
{카테고리_이름} ALISEO VentilClima 010 LCD 2T에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALISEO VentilClima 010 LCD 2T 6 페이지. On board electronic control minislim
페이지 인쇄
010 LCD 2T / 010 LCD 4T
1.4
General On Switch
In order to manage the device via the control panel, this
must be connected to the mains electricity.
If a general switch is installed on the power line, this must
1.5
Activation
To activate the device
Key
Operation
Press the ON Stand-by key
Select one of the 4 operating modes by pressing the relative key.
1.6
Heating/cooling operation modes setting
Key
Operation
Keep the Heating / Cooling key pressed for approx. 2 seconds to change the mode
between heating and cooling, which is indicated by the 2 symbols that appear if heating
or cooling is active.
When heating, the symbol displays when the set point is higher than ambient
temperature, both are off when the set point is lower.
When cooling, the symbol displays when the set point is lower than ambient temperature,
both are off when the set point is higher.
In the 4 tube version, with the automatic cooling/heating regulation system, when both
symbols are displayed it signifies the set point having been reached (neutral band).
One of the two symbols flashing means that the water
temperature (hot or cold) is not sufficient, and stops
the fan until the temperature reaches a level suitable for
reaching the required temperature.
If after switching the power on the board detects the
1.7
Stand By
Key
Operation
Press and hold the ON Stand-By key for approx. 2 seconds. No illuminated signals on
the display at all means that the system is in stand-by (no operation).
When the control is in this operating mode, anti freezing is
in any case guaranteed. If the ambient temperature drops
below 5°C, the solenoid valves on the hot water output
1.8
Temperature selection
Key
Operation
Set the required room temperature using the two increase/decrease keys to set the
temperature value on the 3-digit display.
The adjustment range is from 16 to 28°C in intervals of
0.5°C, but out-of-range values are also accepted, from
5°C to 40°C (unless in auto mode).
Only set these values for brief periods, and then set a
www.ventilclima.com
also be switched on.
- Turn the device on by activating the general switch
H2 probe, start-up occurs in normal conditions with the
minimum and maximum thresholds.
The board also has a function when there is no H2 probe,
in such cases the fan stop thresholds are ignored.
and the boiler are opened.
intermediate value.
The controller is very precise - set it to the required value
and wait for the controller to regulate itself according to the
actual room temperature detected.
On board electronic control
Display
From off to on
Display
Display
Off
Display
20.
5
3