Garmin FORERUNNER 935 소유자 매뉴얼 - 페이지 35

{카테고리_이름} Garmin FORERUNNER 935에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin FORERUNNER 935 46 페이지.
Garmin FORERUNNER 935에 대해서도 마찬가지입니다: 소유자 매뉴얼 (42 페이지)

Garmin FORERUNNER 935 소유자 매뉴얼
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.

Cleaning the Device

Even small amounts of sweat or moisture can cause corrosion
of the electrical contacts when connected to a charger.
Corrosion can prevent charging and data transfer.
1
Wipe the device using a cloth dampened with a mild
detergent solution.
2
Wipe it dry.
After cleaning, allow the device to dry completely.
TIP: For more information, go to www.garmin.com/fitandcare.
Replacing the HRM-Swim Battery and the HRM-Tri
Battery
1
Remove the sleeve
from the heart rate monitor module.
2
Use a small Phillips (00) screwdriver to remove the four
screws on the front of the module.
3
Remove the cover and battery.
4
Wait 30 seconds.
5
Insert the new battery under the two plastic tabs
positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.
The O-ring gasket should remain around the outside of the
raised plastic ring.
6
Replace the front cover and the four screws.
Observe the orientation of the front cover. The raised screw
should fit in the matching raised screw hole on the front
cover.
NOTE: Do not overtighten.
7
Replace the sleeve.
After you replace the heart rate monitor battery, you may need
to pair it with the device again.

Changing the Bands

You can replace the bands with new Forerunner bands or
compatible QuickFit
bands.
1
Use the two screwdrivers to loosen the pins.

Troubleshooting

NOTICE
with the
2
Remove the pins.
3
Select an option:
• To install Forerunner bands, align the new bands, and
replace the pins using the two screwdrivers.
• To install QuickFit bands, replace the pins, and press the
new bands into place.
NOTE: Make sure the band is secure. The latch should
close over the watch pin.
Troubleshooting

Viewing Device Information

You can view device information, such as the unit ID, software
version, regulatory information, and license agreement.
1
Hold
.
2
Select Settings > About.
29