A-Collection aFlood LED Slim 800 사용 설명서

{카테고리_이름} A-Collection aFlood LED Slim 800에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Collection aFlood LED Slim 800 8 페이지. Led

페이지 인쇄

LED floodlight

Instruction Manual

Please read the instruction sheet carefully before use:

1. Main structures and application fields

The enclosure of the LED floodlight is made of glass and aluminum alloy with high purity. Intended for outdoor use.

2. Technical data

Model

aFlood LED Slim 800

aFlood LED Slim 2400

aFlood LED Slim 4000

aFlood LED Slim 1600 Sensor

aFlood LED Slim 4000 Sensor

*IP44 Plug To make it an IP65, a permanent connection is required. Depending on the socket's IP Code, use a plug that achieves at least an IP 44.

Required Installation wire:

Protection Class level:

Input voltage:

Range of mounting heights: 1-3 m

3. Attention

(1) In order to ensure the product works properly, please use the power supply within indicating voltage and current;

(2) Cut off supply before installation or repair

(3) If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer

or his service agent or a similar qualified person in order to avoid a hazard.

(4) Luminaire suitable for surface mounted direct on normally flammable surface.

(5) If the protective glass is damaged or cracked, do not use the armature and discard it.

(6) The luminaire should be at least 1m distance from projection object

(7) The light source of this luminaire is not replaceable. When the light source reaches its end of life the whole luminaire

shall be replaced.

(8) In case of radiation interference, PIR sensor may be affected, lights will turn on even without induction.

(9)The glass is tempered glass, will form small particles after impact and not cause harm to human body.

4. Instruction for sensor ( Detective Angle 120°)

When somebody pass by the detective range of sensor, the light will turn on automatically. And it will turn off when

there is no continuous action in a setting time. The detective distance, working delay time and sensitive illumination can

be adjusted according to requirement.

1) SENS: Adjust the detective distance of sensor ( 2-8M ).

A. Set it to Max., the longest distance is 8 meters.

B. Set it to Min., the longest detective distance is 2 meters.

2) TIME: Adjust the working delay time (10 seconds - 10 minutes).

A. Set it to MAX., the light will turn off automatically after 10 minutes approximately when there is no continuous action.

B. Set it to Min., the light will turn off automatically after 10 seconds approximately when there is no continuous action.

3) LUX: Sensitive illumination (5-2000LUX)

A. Set it to MAX., the light can turn on automatically when somebody move into the detective range, both in daytime

and at night.

B. Set it to Min., the light will turn on automatically only at night when somebody move into the detective range.

5. Environmental protection

IP Classification Input

Power

IP65*

10W

IP65*

30W

IP65*

50W

IP44

20W

IP44

50W

3G*1.0 mm H05RN-F 300/500V

Class I

AC220-240V 50/60Hz

Weight

Maximum

Projected Area

530G

0.013 m²

830G

0.035 m²

1210G

0.047 m²

670G

0.024 m²

1270G

0.057 m²

Size

125*104*27 mm

209*168*27 mm

237*200*36 mm

189*125*55 mm

287*200*57 mm