Garmin 010-C0616-00 - MapSource BlueChart g2 사용자 설명서 - 페이지 18
{카테고리_이름} Garmin 010-C0616-00 - MapSource BlueChart g2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 010-C0616-00 - MapSource BlueChart g2 30 페이지. Software de mapeamento
Garmin 010-C0616-00 - MapSource BlueChart g2에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 소유자 매뉴얼 (2 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (28 페이지), (포르투갈어) 사용자 설명서 (30 페이지)
페이지 인쇄
u
M
s
>
t
sIng
ap
ource
ransferrIng
Sending Data to Your GPS Unit
If your GPS unit has a storage card, verify that the card
is inserted correctly into the unit. Also, connect your
GPS unit to your computer and set your unit's Data
Transfer mode to Garmin, if applicable (see your unit
owner's manual for instructions).
You can send maps, waypoints, routes, or tracks to
your GPS unit.
NOTE: MapSource transfers all of the data listed
in a data tab to your GPS unit each time you
transfer data.
To send data to a GPS unit or card reader:
1. Verify that the data you want to send appears in
the corresponding data tabs on the left side of
the MapSource window.
2.
Click Send To
Device
Send To
Device.... The name of your GPS unit
or card reader should appear automatically in
the Device menu. If not, click Find
M
s
d
ap
ource
ata
or click Transfer >
Device.
• If you are using a USB card programmer,
"USB Data Card Programmer" appears in
the Device field.
• If you are using a CF or SD card reader,
select the correct drive letter from
the Device field. For example, select
"Removable Disk (E:)."
• If you are sending data to an iQue or cf
Que, select where you want to save data
under Map Storage Location. If necessary,
select the correct user name from the
Device fields.
3. Under What to Send, check the boxes next to
each type of data you want to send.
4. Click Send. MapSource begins sending data to
your GPS unit or card reader. After you begin
transferring data, you can check the box next to
Turn Off GPS After
5. If you are using an iQue or cf Que, synchronize
with your personal computer, if necessary, so
that your unit receives the data.
Transfer, if available.
MapSource User's Manual