Aliyiqi ATL-10 사용자 설명서 - 페이지 4

{카테고리_이름} Aliyiqi ATL-10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aliyiqi ATL-10 6 페이지. Digital tension meter

：Press this button,power on /off.

2.1.1 ON/OFF

SET：Enter into setting menu via this button.

2.1.2

UNIT/▽：Press this button to switch units in measuring interface ,it can move down when in

2.1.3

setting interface.

ZERO：In measuring interface,press this button to clear the screen.

2.1.4

PEAK/△：Press this button to switch peak state in measuring interface,it can be move up when

2.1.5

in setting interface.

CLEAR：It has same function with ZERO button ,more convenient for using.

2.1.6

Mesauring rod：Used for testing the force value.

2.1.7

 Usage & Operation

3.1 Arrangements and check before using

3.1.1 The instrument has no function of charging,should be check whether the measurement rod is fixed before

using ,should be check whether the sensor is in good response or not .

3.1.2 The new instrument has built-in battery isolation ,if the it can not start on,put the battery isolation out first

and then re-start.

3.2 The operation and instruction in use

（ HIDT ） Upper limit value setting: If it exceed the upper limit value,the screen

3.2.1

shows"MAX".Power on ,enter into measuring interface, press "SET" key into setting interface, press

again to enter into upper limit value setting ,press " "key and" ",to choose the number you

need ,press "SET" key to save,and it will back to setting interface automatically .As the pictures

shows：

4 / 6

（To test dental arch wire tension force）