Brother 2340CV 운영 매뉴얼 - 페이지 12
{카테고리_이름} Brother 2340CV에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 2340CV 40 페이지. User manual - french and nederlands
Brother 2340CV에 대해서도 마찬가지입니다: 서비스 매뉴얼 (16 페이지), (프랑스어) 마누엘 디렉션 (41 페이지)
페이지 인쇄
Looper threading
3
A
4
•
Pass each thread from 3 to 4 as shown in
this illustration.
•
Pass the thread through the proper thread
guide.
•
Slide and hold the thread tension release
button to the right, then pass the thread
through the tension disc which is in the
channel next to the tension adjustment dial.
Release the button.
A Tension disk
B Thread tension release button
C
B
A
10
3
B
1
2
3
4
5
D
7
8
6
0
9
CAUTION
Always be sure to turn off the power before
carrying out the following operation.
(1) Follow the procedure described below to thread the
looper.
1 Open the front cover by sliding to the right and guiding
the top toward you.
2 Run the thread in the sequence illustrated, following
the blue color and the numbers next to each threading
point. (1-0)
3 After running the thread to 0, pull the release lever A,
and then run the thread through B and C.
4 With about 10 cm (4 inch) of thread pulled through the
eye of the needle, as shown by D in the illustration,
move the looper back in the direction of the arrow to
lock it.
5 Close the front cover.
NOTE:
When using thick thread, such as decorative thread,
as the looper thread, run the thread as shown in the
illustration.
A
Do not run the thread through A.