Brother 888-N20 운영 매뉴얼 - 페이지 10
{카테고리_이름} Brother 888-N20에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 888-N20 32 페이지.
Brother 888-N20에 대해서도 마찬가지입니다: 운영 매뉴얼 (32 페이지)
페이지 인쇄
2
Raise the needle to its highest position�
Turn toward you so that this mark
points up to the highest position�
3
If the power of the machine is on, turn it off�
4
Pull up the spool pin as far as
possible, and put a spool of
thread on this pin�
5
Pass the thread through the thread channel in the
order shown below�
* Follow the numbered path printed on the machine�
Thread take-up lever
6
Slide the thread behind
the needle bar thread
guide�
7
Insert the thread through the eye of the needle
from front to back, and then pass the thread
under the presser foot�
10
or
Press once or twice�
Make sure that the thread
unwinds as shown�
Make sure that the thread
unwinds as shown�
Needle bar thread guide
10 cm (4 inches)
n Using the needle threader
★
• The needle threader can only be used with
home sewing machine needles size 75/11-
100/16� If you are using transparent nylon
monofilament thread, you can only use
needles in the range of 90/14-100/16�
• You cannot use the needle threader if you
are using decorative threads or special
needles, such as the twin needle and wing
needle� If you are using those types of
threads or needles, thread the eye of the
needle by hand� Make sure the main power
switch is off when threading the needle�
1
Follow steps
2
<Type A>
a) Pass the thread behind the guide (1), and
insert the thread into the slit of the thread
guide disk (2) firmly� Next, cut the thread
with the thread cutter (3)�
2
Thread guide
disk
b) Lower the presser foot lever�
c) Lower the needle threader lever fully until
it stops (4), and push it back slowly until it
stops (5)�
4
* Make sure that the hook passes through the
eye of the needle, and catch the thread�
<Type B>
a) Lower the presser foot lever�
★
CAUTION
1
6
to
of "Upper threading"�
Thread cutter
Guide
3
1
5
★
: Only for some models�
Hook