Garmin Cessna Caravan G1000 파일럿 매뉴얼 - 페이지 9

{카테고리_이름} Garmin Cessna Caravan G1000에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Cessna Caravan G1000 25 페이지. Integrated flight deck
Garmin Cessna Caravan G1000에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (16 페이지), 파일럿 매뉴얼 (6 페이지), 파일럿 매뉴얼 (32 페이지), 파일럿 매뉴얼 (34 페이지), 파일럿 매뉴얼 (21 페이지), 비행기 비행 매뉴얼 보충 자료 (33 페이지), 파일럿 매뉴얼 (22 페이지)

RADIO STATUS

When a COM radio is keyed, a white TX indication

appears to the right of the active COM frequency to indi-

cate that a transmission is in progress. The TX indication

disappears once COM transmission is completed.

When a COM signal is received, a white RX indication

appears to the right of the active COM frequency to indi-

cate that a COM signal reception is in progress. The RX

indication disappears once COM signal reception is over.

Figure 4.2.6 Radio Status Indications

NOTE: If a signal is transmitted or received on

a COM radio for which frequency toggling is

enabled (i.e., on which the tuning box is located),

the Frequency Toggle Arrow disappears and

is replaced by a TX or an RX indication, respec-

tively.

EMERGENCY FREQUENCY (121.500 MHZ)

When a COM tuning failure is detected by the system,

the emergency frequency (121.500 MHz) is automatically

loaded in the active frequency ﬁeld of the COM radio for

which the tuning failure was detected.

Figure 4.2.7 COM Tuning Failure

NOTE: In the event of a dual display failure,

the emergency frequency (121.500 MHz)

automatically becomes available to the pilot

through the pilot headset.

190-00445-00 Rev. A

Garmin G1000 VHF NAV/COM Pilot's Guide for Mooney M20M & M20R

Quickly Tuning and Activating 121.500 MHz

Pressing and holding the COM Frequency Toggle key

for approximately two (2) seconds automatically loads the

emergency COM frequency (121.500 MHz) in the active

frequency ﬁeld of the COM radio for which frequency

toggling is enabled.

Figure 4.2.8 Quickly Tuning 121.500 MHz

If the COM1 (or COM2) push-to-talk (PTT) switch be-

comes stuck, or is accidentally left in the keyed position,

or if a signal continues to be transmitted after the switch

is released, the COM transmitter automatically times out

(i.e., ceases to transmit) after 35 seconds of continuous

transmitting and an alert appears on the PFD to advise the

crew of a stuck COM microphone (see ﬁgure below).

Figure 4.2.9 Stuck COM Microphone Alert

OPERATION – COM

4-7