Garmin Cessna Caravan G1000 파일럿 매뉴얼 - 페이지 17

{카테고리_이름} Garmin Cessna Caravan G1000에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Cessna Caravan G1000 34 페이지. Integrated flight deck
Garmin Cessna Caravan G1000에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (16 페이지), 파일럿 매뉴얼 (6 페이지), 파일럿 매뉴얼 (32 페이지), 파일럿 매뉴얼 (25 페이지), 파일럿 매뉴얼 (21 페이지), 비행기 비행 매뉴얼 보충 자료 (33 페이지), 파일럿 매뉴얼 (22 페이지)

페이지 인쇄

Section 3: NAV Frequency

3.1 OVERVIEW

The G1000 NAV radios operate in the aviation fre-

quency band of 108.00 to 117.95 MHz, with 50 kHz

channel spacing.

The Navigation Frequency window is located to the

left of the Navigation Status bar, provides the control and

display of dual VOR/ILS receivers ( NAV1 and NAV2) and

displays the following information:

• NAV1 and NAV2 active and standby frequencies

• NAV1 or NAV2 identiﬁ er indication

NAV frequency is a valid frequency and its Morse

code identiﬁ er signal is received by the system).

• Color code indication of the selected NAV receiver

• Indication of the Morse code identiﬁ er ﬁ lter status

3.2 VOLUME

Volume level for the NAV radios can be adjusted by

using the VOL/PUSH ID knob (top knob on the left

side of the display) located above the NAV Frequency

Toggle key. Turning the VOL/PUSH ID knob clockwise

increases volume level, while turning this knob counter-

clockwise decreases volume level.

190-00302-01 Page Rev. 1

G1000_COM-NAV_PG.indd 9

Window

(if the active

Garmin G1000 VHF NAV/COM Pilot's Guide

OPERATION – AUTO-TUNING

3.3 MORSE CODE IDENTIFIER

Pressing the VOL/PUSH ID knob toggles the Morse

code identiﬁ er ﬁ lter ON and OFF for the active NAV fre-

quency next to which the tuning box is located. When

the Morse code identiﬁ er ﬁ lter is ON, an ID indication

appears to the left of the corresponding active NAV fre-

quency.

The Morse code identiﬁ er ﬁ lter is ON for

the GHM VOR.

Figure 3-1 ID Indication

The Morse code identiﬁ er for an active NAV frequency

can only be heard if the Morse code identiﬁ er ﬁ lter for

the corresponding NAV radio is turned on (i.e., if the ID

indication appears next to the active NAV frequency) and

if the corresponding NAV radio is selected on the GMA

1347 audio panel (i.e., the associated NAV radio annun-

ciator lights are illuminated).

Here, since NAV2 is the only

NAV radio selected on the

audio panel, only the Morse

code identiﬁ er for the GHM

VOR can be heard.

Figure 3-2 Morse Code Identiﬁ er Audio

NAV portion of

the GMA 1347

audio panel

Garmin Proprietary

2/10/2004, 8:47:53 AM