Brother 929D 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Brother 929D에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 929D 20 페이지.

1. With the needle raised to 2.2 ~ 2.6 mm above its lowest position and the point of the lowerlooper

contacting the right side of the needle, check that the distance between the lowerlooper and the

movable needle guard is 1.2 ~ 1.5 mm and that the distance between the needle and the movable

needle guard is 0 ~ 0.1 mm.

2. In order to make an adjustment, loosen set screw D , move the movable needle guard upward,

downward, forward and backward to adjust it to meet the specifications described in 1.

3. Firmly tighten set screw D .

(D) Adjust the needle and the fixed needle guard

1. Before adjustment, remove the stitch tongue.

2. With the needle raised to 2.2 ~ 2.6 mm above its lowest position and the point of the lower looper

contacting the right side of the needle, check that the distance between the needle and the fixed

needle guard is 0 ~ 0.05 mm.

3. In oder to make the adjustment, loosen set screw E .

Rotate the fixed needle guard and move it forward and backward, then adjust it so it meets the

specifications described in 1.

NOTE: With the needle plate installed check that the fixed needle guard does not contact the needle.

4. Firmly tighten set screw E .

NOTE: Incorrectly setting the clearance between the needle and the lowerlooper, movable needle guard and

fixed needle guard can cause the needle to break or skip stitches.

www.promelectroavtomat.ru

- 5-