Garmin GDL 69A 활성화 지침 - 페이지 20
{카테고리_이름} Garmin GDL 69A에 대한 활성화 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GDL 69A 38 페이지. Xm satellite radio instructions for continued airworthiness
Garmin GDL 69A에 대해서도 마찬가지입니다: 활성화 지침 (46 페이지), 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 부록 (50 페이지), 활성화 지침 (16 페이지), 사용 설명서 (44 페이지), 사용 설명서 (8 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
5. Refer to Table 4-1 to read the SAT ID/CONNECTIVITY information.
6. Verify radio IDs and signal quality is between 2 – 3. If signal quality is zero, check the antenna and
wiring.
'- -'
'XM'
'X0', 'X1', 'X2', or 'X3'
'-0', '-1', '-2', or '-3'
"Searching..."
"Satellite in view"
4.3 Verify XM Subscribed Services
The 430/530 supports the following weather services: NEXRAD, graphical METAR, text-based METAR,
Wind, and Graphical Temperature/Dew Point. These services are available only in the United States.
Verify included services by displaying them on the unit, if applicable. If signal quality is between 1 and
3, but no data is displayed, contact XM Satellite Radio to verify subscription. Be sure that the unit is
updated with the most current software.
Page 14
190-00355-04
Figure 4-2. Data Link Status Page
Table 4-1. Data Link Status
GDL 69/69A – 430/530 Series interface communications not yet established.
GDL 69/69A not yet communicating with internal satellite radio hardware (normal
during power-up).
'X' = Satellite radio service activated. Satellite signal quality is indicated by the
numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
'-' = Satellite radio service is not activated. Satellite signal quality is indicated by
the numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
Connectivity Field
No satellite is currently in view, signal quality is '0'.
Indicates a signal quality between 1 and 3.
SAT ID Field
XM Activation Procedures
Rev. H