Garmin GNS 430A 파일럿 매뉴얼 부록 - 페이지 19

{카테고리_이름} Garmin GNS 430A에 대한 파일럿 매뉴얼 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GNS 430A 27 페이지. Friendlypanels gps for microsoft fs9 & fsx
Garmin GNS 430A에 대해서도 마찬가지입니다: 사용 설명서 (6 페이지), 파일럿 매뉴얼 부록 (4 페이지), 빠른 참조 (23 페이지), 파일럿 매뉴얼 부록 (22 페이지), 사양 (2 페이지), 운영 매뉴얼 (27 페이지)

페이지 인쇄

All information in this section pertaining to the display and control of the Ryan 9900B TCAD also

applies to the Ryan 9900BX TCAD except for the following:

• TCAS-like symbology is used in the 9900BX as opposed to the 9900B (similar to SKYWATCH).

• Altitude modes are available similar to SKYWATCH (normal, look up, look down, unrestricted).

• Ranges are manually controlled instead of being automatically re-sized to the current shield.

• Trafﬁ c display range selections are different:

• Ryan 9900B— range is slaved to current shield size.

• Ryan 9900BX— 2 nm, 2 and 6 nm, 6 and 12 nm, 12 and 24 nm.

Ryan TCAD Description

Refer to the Ryan TCAD Pilot's Guide for a detailed description of the Ryan TCAD System.

The Ryan TCAD (Traffic and Collision Alert Device) is an on-board air traffic display used to identify

potential collision threats. TCAD computes relative altitude and range of threats from nearby Mode C and

Mode S-equipped aircraft. TCAD will not detect aircraft without operating transponders and those that

are beyond radar coverage. TCAD, within defined limits, creates a shield of airspace around the aircraft,

whereby detected traffic cannot penetrate without triggering an alert.

SECTION 4

RYAN TCAD INTERFACE

Section 4

Ryan TCAD Interface

See the Ryan TCAD Pilot's Handbook for a

description of the trafﬁ c symbols.