Garmin GNS 430A 파일럿 매뉴얼 부록 - 페이지 23

{카테고리_이름} Garmin GNS 430A에 대한 파일럿 매뉴얼 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GNS 430A 27 페이지. Friendlypanels gps for microsoft fs9 & fsx
Garmin GNS 430A에 대해서도 마찬가지입니다: 사용 설명서 (6 페이지), 파일럿 매뉴얼 부록 (4 페이지), 빠른 참조 (23 페이지), 파일럿 매뉴얼 부록 (22 페이지), 사양 (2 페이지), 운영 매뉴얼 (27 페이지)

페이지 인쇄
Garmin GNS 430A 파일럿 매뉴얼 부록

TCAD Setup Page

The Ryan TCAD Setup Page is accessed from the Traffic Page. The TCAD Setup Page allows you to
configure traffic data. The definitions of the available options are listed in the TCAD Pilot' s Handbook.
To change a TCAD setup option:
1. Turn the small right knob to select the Traffic Page. Press MENU to display the Page Menu. Turn the small
right knob to select 'Setup?' and press ENT.
2. The flashing cursor highlights the Mode field. Turn the small right knob to select the mode and press ENT.
The mode selection determines which shield definition to display and change. Turn the large right knob to
select the desired remaining options fields. Turn the small right knob to select the desired option and press
ENT.
3. Return to the Traffic Page by pressing CLR.
Traffi c Page Fields
There are two selectable fields on the Traffic Page: the Operating Mode Field and the Barometric
Pressure Field. The Operating Mode Field selects the TCAD operating mode. Please, refer to the TCAD
Pilot' s Handbook for a complete description of all modes of operation. For the 9900BX model, this field is
replaced with the SKYWATCH style altitude mode.
To select the Operating Mode:
1. From the Traffic Page, press CRSR to highlight the operating mode field. Turn the small right knob to select
the desired operating mode and press ENT.
The traffi c display range is automatically set to the shield size and cannot be changed
(9900B only).
Section 4
Ryan TCAD Interface
Ryan TCAD Setup Page (9900B only)
21