Garmin Astro 220 설정 매뉴얼 - 페이지 4

{카테고리_이름} Garmin Astro 220에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Astro 220 6 페이지. Declaration of conformity
Garmin Astro 220에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 적합성 선언 (1 페이지), 사양 (2 페이지)

페이지 인쇄

Buttons at the bottom of the page allow you to route to the

dog's last location, view that location on the Map page, and

reset distance traveled and average speed data for your dog.

NOTE: If you have purchased additional DC 20 Dog Units, they may

be added to the Astro 220 Handheld Unit dog list to allow multiple

dog tracking as explained in the Astro 220 Owner's Manual.

Attach the DC 20 to Your Dog

➎

Initially, use only one DC 20 and dog to learn how to use the

Astro Dog Tracking System before taking it into the field. Before

using it in an actual hunt, it is recommended that you fully charge

the DC 20. (See the Owner's Manual.) Do not operate the DC 20

without the antenna attached, as damage can occur.

Using the DC 20 with the Dog Harness

Remove the collar attachment plate, if already attached, from

the base of the DC 20. Make certain the DC 20 is on and is

communicating with the Astro 220.

Lay out the dog harness upside-down and separate the hook

and loop closure revealing the pocket for the DC 20.

Insert the DC 20, antenna first. Orient the DC 20 so that it will

be in line with the dog's spine when the harness is attached

and the Power key and LED are visible through the opening in

the harness.

Open the collar strap and extend it out. Facing the dog,

slide the end of the strap under the collar.

Fip the harness over onto the dog's back and fasten the

strap in place under the harness.

Collar strap

(Loop over and

then back under

the dog's collar)

Position the harness just behind the dog's shoulders

with the collar strap extended from the dog's collar. Then

wrap the torso straps under the dog's chest and connect

the hook and loop portions until snug enough to prevent

shifting.

DC 20

Torso strap

(Trim off extra strap

sections, if not needed.)