Garmin echomap 50 series 소유자 매뉴얼 - 페이지 45

{카테고리_이름} Garmin echomap 50 series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin echomap 50 series 50 페이지. Flat-mount kit
Garmin echomap 50 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지), 소유자 매뉴얼 (38 페이지), 소유자 매뉴얼 (44 페이지), 소유자 매뉴얼 (30 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (34 페이지)

페이지 인쇄

You can check this several ways. For example, you can

check whether other devices powered by the source are

functioning.

• Check the fuse in the power cable.

The fuse should be located in a holder that is part of the red

wire of the power cable. Check that the proper size fuse is

installed. Refer to the label on the cable or the installation

instructions for the exact fuse size needed. Check the fuse to

make sure there is still a connection inside of the fuse. You

can test the fuse using a multimeter. If the fuse is good, the

multimeter reads 0 ohm.

• Check to make sure the device is receiving is at least 10 V,

but 12 V is recommended.

To check the voltage, measure the female power and ground

sockets of the power cable for DC voltage. If the voltage is

less than 10 V, the device will not turn on.

• If the device is receiving enough power but does not turn on,

contact Garmin product support at www.garmin.com/support.

My device is not creating waypoints in the correct

location

You can manually enter a waypoint location to transfer and

share data from one device to the next. If you have manually

entered a waypoint using coordinates, and the location of the

point does not appear where the point should be, the map

datum and position format of the device may not match the map

datum and position format originally used to mark the waypoint.

Position format is the way in which the GPS receiver's position

appears on the screen. Commonly displayed as latitude/

longitude in degrees and minutes, with options for degrees,

minutes and second, degrees only, or one of several grid

formats.

Map datum is a math model which depicts a part of the surface

of the earth. Latitude and longitude lines on a paper map are

referenced to a specific map datum.

Find out which map datum and position format was used

when the original waypoint was created.

If the original waypoint was taken from a map, there should

be a legend on the map that lists the map datum and position

format used to create that map. Most often this is found near

the map key.

On the chartplotter, select Settings > Units.

Select the correct map datum and position format settings.

Create the waypoint again.

The touchscreen is not responding to my touches

If the screen is not properly responding to your touches, you

should calibrate the screen. See

page

38. The chartplotter touchscreen does not normally require

calibration.

NMEA 0183 Information

Type

Sentence

Transmit GPAPB

GPBOD

GPBWC

GPGGA

GPGLL

GPGSA

GPGSV

GPRMB

Appendix

Calibrating the Touchscreen,

Description

APB: Heading or track controller

(autopilot) sentence "B"

BOD: Bearing (origin to destination)

BWC: Bearing and distance to waypoint

GGA: Global positioning system fix

data

GLL: Geographic position (latitude and

longitude)

GSA: GNSS DOP and active satellites

GSV: GNSS satellites in view

RMB: Recommended minimum

navigation information

Type

Sentence

GPRMC

GPRTE

GPVTG

GPWPL

GPXTE

PGRME

PGRMM

PGRMZ

SDDBT

SDDPT

SDMTW

SDVHW

Receive DPT

DBT

MTW

VHW

WPL

DSC

DSE

HDG

HDM

MWD

MDA

MWV

VDM

You can purchase complete information about National

Marine Electronics Association (NMEA) format and

sentences from: NMEA, Seven Riggs Avenue, Severna Park,

MD 21146 USA (www.nmea.org)

NMEA 2000 PGN Information

Type

PGN

Transmit and receive 059392 ISO acknowledgment

059904 ISO request

060928 ISO address claim

126208 NMEA: Command, request, and

126996 Product information

127250 Vessel heading

128259 Speed: Water referenced

128267 Water depth

129539 GNSS DOPs

129799 Radio frequency, mode, and power

130306 Wind data

130312 Temperature

Transmit

126464 Transmit and receive PGN list group

127258 Magnetic Variance

129025 Position: Rapid update

129026 COG and SOG: Rapid update

129029 GNSS position data

129283 Cross track error

129284 Navigation data

129285 Navigation route and waypoint info

129540 GNSS satellites in view

Receive

127245 Rudder

127250 Vessel heading

Description

RMC: Recommended minimum specific

GNSS data

RTE: Routes

VTG: Course over ground and ground

speed

WPL: Waypoint location

XTE: Cross track error

E: Estimated error

M: Map datum

Z: Altitude

DBT: Depth below transducer

DPT: Depth

MTW: Water temperature

VHW: Water speed and heading

Depth

Depth below transducer

Water temperature

Water speed and heading

Waypoint location

Digital selective calling information

Expanded digital selective calling

Heading, deviation, and variation

Heading, magnetic

Wind direction and speed

Meteorological composite

Wind speed and angle

AIS VHF data-link message

Description

acknowledge group function

function