Garmin Fishfinder 240 Blue 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Garmin Fishfinder 240 Blue에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fishfinder 240 Blue 50 페이지. Garmin fishfinder 160 blue owner's manual
Garmin Fishfinder 240 Blue에 대해서도 마찬가지입니다: 소유자 매뉴얼 (50 페이지), 파일럿 매뉴얼 (12 페이지), 사양 (2 페이지), 사양 (2 페이지), 소유자 매뉴얼 (50 페이지), 소유자 매뉴얼 (50 페이지)

페이지 인쇄

In-hull Installation

The 010-10224-00 transducer is designed to be mounted inside a

fiberglass hull. The standard plastic transom mount transducer can also be

mounted in this fashion using this method. If using a temperature sensing

transducer, the temperature displayed will reflect the hull temperature.

Selecting a Location

The location has to be solid ﬁ berglass, devoid of any air bubbles,

laminates, ﬁ llers or dead air space. The location needs to be in an

area of clean water at all speeds. Do not place the transducer over

any strakes or behind any obstruction on the hull that would create

turbulence at speed.

Many modern hulls have a prelocated pocket for In-hull transducer installation.

If you are unsure if your hull is equipped with a prelocated pocket, contact

your hull manufacturer.

Testing the Location

Place the transducer in the water, pointed directly at the bottom and set

unit for optimum performance. Place the transducer in the test device as

show on the side bar. If the sonar performance is signiﬁ cantly degraded,

another location will need to be tested.

Installing the Transducer

1. Lightly sand the surface of the hull and face of the transducer with 400

grit wet or dry sandpaper.

2. Build a dam using strip caulk about 1/4" tall. Pour about 1/8" of two

part, slow cure epoxy in the dam. Place the transducer in the epoxy,

turning the transducer to work out any air bubbles.

3. Weight the transducer in place and allow to cure for 24 hours.

Installation

Mounting the Transducer

PVC Pipe

or a Can

Strip Caulk or

RTV Sealer

Hull Surface

Testing the Location

Weight transducer in place

Apply twisting motion

for at least 24 hours

to eliminate any

trapped air bubbles

Installing the Transducer

Weight

transducer to

hold it in place

Fill Pipe or Can

with water or a

light mineral oil

Slow cure two

part epoxy

Strip Caulk or

RTV Sealer