Garmin Fishfinder 340C 설치 매뉴얼

{카테고리_이름} Garmin Fishfinder 340C에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fishfinder 340C 1 페이지. Declaration of conformity
Garmin Fishfinder 340C에 대해서도 마찬가지입니다: 빠른 참조 (2 페이지), 적합성 선언 (1 페이지)

페이지 인쇄

Unit outline

Cut the mounting surface along the

inside of this line. Be very careful

when cutting this hole; there is only a

small amount of clearance between the

unit and the mounting holes.

1. Trim and tape this template to the mounting location. Avoid cable areas.

2. Drill four 1/8" (3 mm) mounting holes at the indicated locations.

3. Drill a 3/8" (10 mm) hole at the location indicated on this template, and then

use the jig saw to cut the panel along the inside of the indicated line.

4. Install the four mounting studs into the unit by screwing the shorter section

into the back of the unit.

5. Use a 0.05" Allen wrench to tighten the mounting studs until the stop

contacts the case. Be careful not to overtighten, because this can damage the

mounting stud! The studs have a reusable thread-locking patch pre-applied

from the factory.

6. Place the unit into the cut out of the mounting surface.

7. Place washers over the mounting studs, and then thread on one hex nut per

mounting stud.

8. Tighten all four hex nuts until the unit is snug against the mounting surface.

9. Install and tighten the second hex nut on all four mounting studs to lock

the first one into place.

April 2006

Flush Mount Template

4.33"

�110.0 mm)

Part Number 190-00658-02 Rev. B

Drill mounting holes

1/8"

(3.0mm)

Drill a 3/8" hole, and

begin cutting here.

5.58"

(141.6 mm)

Printed in Taiwan