Garmin GPS 16 Series 기술 사양 - 페이지 39
{카테고리_이름} Garmin GPS 16 Series에 대한 기술 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPS 16 Series 40 페이지. Gps receiver / antenna
Garmin GPS 16 Series에 대해서도 마찬가지입니다: 적합성 선언 (1 페이지), 기술 사양 (37 페이지), 빠른 시작 매뉴얼 (16 페이지)
페이지 인쇄
File Menu
The File Menu allows you to open, save, and print sensor configurations. The items in the File Menu work
like most Windows-based programs.
Comm Menu
The Comm (Communication) Menu allows you to set the port number, baud rate, and then connect and
disconnect from the sensor.
Disconnect: Select Disconnect to disconnect from
the sensor.
Config Menu
The Config (Configuration) Menu allows you
configure the sensor as it is connected.
Sensor Configuration (F6): Opens the Sensor
Configuration Window, shown to the right. Many
of the fields in this window should be left alone.
Please refer to the beginning of this document for
specific information about some of these fields.
For the most part, this window is used to enter a
new Latitude, Longitude, and Altitude for the
sensor. This is especially helpful when you are
programming the sensor for use in a particular
geographic location.
Resetting the Unit (Reset Unit) performs a reset
on the unit, much like cycling the power.
Resetting the non-volatile memory (Reset
NonVol) will clear all of the data from the non-
volatile memory.
NMEA Sentence Selections (F7): Displays the
NMEA Sentence Selections Window. If the
sentence is enabled, a check mark appears in the
box to the left of the sentence name. Click the box
to enable or disable to the sentence.
190-00228-20
Setup: Opens the Comm Setup Window, shown to the left. Select
the Serial Port to which the sensor is connected from the drop-
down list. Then select Auto (the program determines the baud rate
on its own) or Manual (you then enter the baud rate) for the Baud
Rate entry.
Connect: Select Connect to connect to the sensor to change or
view the configuration.
GPS 16/17 Technical Specifications
Page 35
Rev. C