Garmin GPSMAP 17 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Garmin GPSMAP 17에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 17 16 페이지. Gps receiver/antenna
Garmin GPSMAP 17에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지), 참조 매뉴얼 (1 페이지), 기술 참조 (30 페이지), 설치 지침 매뉴얼 (17 페이지), 설치 지침 매뉴얼 (19 페이지), 적합성 선언 (1 페이지), 기술 사양 (40 페이지)

Three common sources of interference for GPS units are:

ABOVE- OK

Radar

BELOW- OK

Radar

EMI

EMI (Electromagnetic Interference) from engine components

If a problem is found, try altering the location of the unit

or wiring. Often moving the antenna a few feet away from the

source of interference will solve the problem. When a suitable

conﬁguration is found, a permanent installation should be

made. Select the mounting location according to your prefer-

ences. Keep in mind that from this mounting location cables

will be routed to the NMEA listening device.

Mounting the GPS 17 with cable outside mount:

1. Place the cable in the vertical slot along the side of the

base of the unit.

2. Screw the GPS 17 onto the mount. Make sure that you

do not overtighten the head. It is possible to tighten the

unit to the point that the cable may be cut in two.

3. With the GPS 17 and mount installed, ﬁll the remaining

gap in the cable exit on the with a marine sealant.

4. Route the power/data cable from the GPS 17 to the

desired device. Excess cable may be shortened or coiled

together and secured in an inconspicuous location.

VHF Radio Antenna

Installation

Mounting the

GPS 17

When routing the power/data

cable, try to avoid:

• Sharp edges which may cut

the cable.

• Routing the cable parallel to

other power lines.

• Excessively twisting, straining

or bending the cable.