alkitronic EAF 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} alkitronic EAF에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. alkitronic EAF 16 페이지. Battery powered torque multiplier

Operating and service manual

4. Operation alkitronic® EAF

The alkitronic® EAF must not be damp or wet, neither

operated nor stored in moist or humid environment.

Always provide rain protection. Before first use al-

ways fully charge the battery pack. Before any later

use always check the charge status of the battery

pack and recharge, also in case of power decrease.

4.1

4.1.1 alkitronic® Li-Ion battery pack

Remove / charge / insert or change

Remove battery pack

Push safety catch (5), pull battery pack to the front (6).

Charge battery pack

Push the battery pack com-

pletely onto the seat of the

charger.

Insert battery pack

Push the battery pack into the battery seat of the power tool

all the way (7) until the safety catch locks audibly.

4.1.2 Battery pack, capacity and signal display*

Push button (8) on the battery pack and check the

charge status. If the battery pack is almost empty it

must be recharged! Replace the battery pack on the

power tool.

If one of the LEDs flashes the battery pack is almost

empty. The electronic circuitry protects the battery

pack against damage due to complete discharge. Re-

place battery back on the power tool. Recharge bat-

tery pack!

* The charge status indicators are approximate and may be

slightly different depending on the battery pack type.