Garmin GPSMAP 5208 - Marine GPS Receiver 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Garmin GPSMAP 5208 - Marine GPS Receiver에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 5208 - Marine GPS Receiver 19 페이지. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Garmin GPSMAP 5208 - Marine GPS Receiver에 대해서도 마찬가지입니다: 중요 안전 정보 (4 페이지), 빠른 참조 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 기술 참조 (30 페이지), 설치 지침 매뉴얼 (25 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (25 페이지), 적합성 선언 (1 페이지), 인쇄 매뉴얼 (2 페이지), 보충 설명서 (24 페이지), 사용자 설명서 (6 페이지)

Garmin GPSMAP 5208 - Marine GPS Receiver 설치 지침 매뉴얼
To attach the enclosed pole mount adapter to the GPS 17:
1. Thread the cable though the pole mount adapter.
2. Align the tab on the pole mount adapter to the notch on the
GPS 17.
3. Use the enclosed screws to secure the pole mount adapter to
the base of the GPS 17.
Attaching the Pole Mount Adapter to the GPS 17
GPSMAP 4000/5000 Series Installation Instructions
Align Notch
To mount the GPS 17 with the cable run outside the
mount:
1. Place the cable in the vertical slot along the base of the
assembled GPS 17 and pole mount adapter.
2. Screw the assembled GPS 17 and pole mount adapter onto
a standard 1" O. D. 14 threads-per-inch marine mount (not
included). DO NOT overtighten the head. Overtightening the
unit may cut the cable.
3. With the GPS 17 installed on the pole mount, fill the remaining
gap in the cable exit with a marine sealant.
4. Fasten the pole mount to the boat if it is not already attached.
5. Route the cable away from sources of electronic interference.
To mount the GPS 17 with the cable run through the
mount:
1. Position a standard 1" O. D. (Outer Dimension), 14 threads-per-
inch marine mount (not included) in the preferred location, and
mark the approximate center of the mount.
2. Drill a hole using a
/
" (19 mm) drill bit for the cable to pass
3
4
through.
3. Fasten the pole mount to the boat .
4. Slide the cable through the pole mount and screw the assembled
GPS 17 and pole mount adapter onto the pole mount.
5. Route the cable away from sources of electronic interference.
Cable run internally
Attaching the GPS 17 to a Pole Mount
Cable run externally
5