alkitronic CLD 105 운영 및 유지보수 매뉴얼 - 페이지 8

{카테고리_이름} alkitronic CLD 105에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. alkitronic CLD 105 12 페이지. Compact torque multiplier

페이지 인쇄

Operating and maintenance manual

2.6.1 alkitronic® CLD, CLS, CLS2

During operation, always hold the alkitronic® CL

multiplier in the axial direction (6) towards the nut,

otherwise this increases the risk of deformation /

damage to the standard nut / connector (4) or the

screw / nut which is to be loosened. Furthermore,

a secure counter-support (5) is no longer guaran-

teed. (Fig. 4)

wrong

Safe support only in the area displayed

For the correct tightening and loosening of screw connec-

tions, the following steps are to be carried out (Fig. 4):

• alkitronic® CL with standard nut / connector (4), place

fully on screw / nut

• The outrigger (DMA) of the alkitronic® CL must absorb

the reaction moment at the height of the standard nut /

connector (4)

• A secure, stable counter support (5) must be ensured

• Always hold the alkitronic® CL in axis (6) to the bolt dur-

ing the process

• After pressing the rocker switch (3) for clockwise rotation,

the motor stops when the desired torque is reached:

a) Counterforce = Motor power

b) Counter torque = Motor torque

c) Predetermined torque is reached

Do not retighten the nut. Because the preset

torque is exceeded and it can lead to dam-

age to the torque multiplier or to the screw /

threaded bolt.

Fig. 4

correct

wrong

Place on next bolt/nut and start bolting process.

If the torque multiplier is not removable from the bolted

joint (torsional forces caused):

• Release the torque multiplier by changing the direction

of rotation

• Briefly press the rocker switch (3, Fig. 4) - counter-

clockwise rotation. In the case of a bolted joint with a

left-hand thread, the direction of rotation is clockwise,

of course.

This leads to a "run free" of the reaction absorber DMA

For your information:

When loosening a bolted connection, up to 20% higher

torque may be required (loosening torque)!

• Remove the machine, place on the next bolt / nut

• Repeat the tightening procedure

2.6.2 alkitronic® RCL

Insert the support pin (8) completely into the

intended fixture (s) of the alkitronic® RCL housing

to prevent damage to the housing.

Secure support only with supporting bolts fully inserted in the

housing shells

The tightening and loosening of bolt connections must be

carried out in principle as with multipliers using an axial

downforce. Due to the radial downforce of the alkitronic® RCL

however, the multiplier is to be operated at a 90 degree angle

to the screw axis (6). The output occurs via a fixed wrench size

(4). In order to reduce to smaller wrench sizes, alkitronic® STA

(7) should be used. A support pin (8) is used as a torque trans-

ducer. A secure, stable counter support (5) must be ensured

(Fig. 5). (See also application drawing Fig. 6.)

Fig. 5

Support