alkitronic CLS 75 운영 및 유지보수 매뉴얼 - 페이지 2
{카테고리_이름} alkitronic CLS 75에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. alkitronic CLS 75 12 페이지. Compact torque multiplier
페이지 인쇄Operating and maintenance manual
Introduction
We congratulate you on the purchase of a compressed air
powered alkitronic® torque multiplier. You have chosen
a high-quality product that sets new standards around
the world and meets high safety standards. To ensure this
high level, the product requires regular maintenance and
care. We therefore ask you to read these operating and
maintenance instructions carefully and to observe the
following points:
The alkitronic® torque multiplier is only to be repaired or
serviced by employees of alki TECHNIK GmbH, by those
trained by alki TECHNIK GmbH or a certified service pro-
vider.
There could be a risk of damage to health and damage to
the equipment if the product is not properly maintained or
operated. In addition, any warranty claim is then forfeited.
These operating and maintenance instructions contain
basic instructions that must be observed during opera-
tion and maintenance. They must therefore be read by the
operating staff prior to commissioning or maintenance.
They must therefore always be available at the area of ap-
plication of the alkitronic® torque multiplier .
These operating and maintenance instructions refer ex-
clusively to the alkitronic® torque multiplier.
Not only the general safety instructions listed under the
section „Labeling instructions" need to be observed but
also supplementary regulations, instructions or advice,
depending on the situation.
Definition of Symbols
Safety instructions.
Non-compliance may result in personal injury
or death.
Safety instructions.
Non-compliance may result in damage to the
alkitronic® torque multiplier, its functions, or
the environment.
Information for proper and safe operation.
Practical advice and information to make work
easier.
Content
1.
1.1
1.2
2.
2.1
2.2
2.3
2.4
2.5
2.6
2.7
3.
3.1
Changing from standard nut / connector and
3.2
Change alkitronic® STA and
support plunger on type RCL
3.3
4.
4.1
4.2
5.
6.
7.
2
Page
3
3
5
5
5
5
5
5
6
6
7
7
8
8
9
9
9
9
10
10
10
10
10
10
11