AEG PROCOMBI PLUSBS730410K 사용자 설명서 - 페이지 44

{카테고리_이름} AEG PROCOMBI PLUSBS730410K에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG PROCOMBI PLUSBS730410K 48 페이지.

페이지 인쇄

www.aeg.com

2. Remove the metal ring and clean the

glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Attach the metal ring to the glass

cover.

5. Install the glass cover.

13. TROUBLESHOOTING

13.1 What to do if...

Problem

The oven does not heat up.

The lamp does not operate.

The display does not show

the time during the off sta-

tus.

The core temperature sensor

does not operate.

WARNING!

Refer to Safety chapters.

The side lamp

1. Remove the left shelf support to get

access to the lamp.

2. Use a Torx 20 screwdriver to remove

the cover.

3. Remove and clean the metal frame

and the seal.

4. Replace the lamp with a suitable 300

°C heat-resistant lamp.

5. Install the metal frame and the seal.

Tighten the screws.

6. Install the left shelf support.

Possible cause

The oven is deactivated.

The clock is not set.

The necessary settings are

not set.

The automatic switch-off is

activated.

The Child Lock is on.

The fuse is released.

The lamp is defective.

The display is deactivated.

The plug of the core tem-

perature sensor is not cor-

rectly installed into the sock-

et.

Remedy

Activate the oven.

Set the clock.

Make sure that the settings

are correct.

Refer to "Automatic switch-

off".

Refer to "Using the Child

Lock".

Make sure that the fuse is

the cause of the malfunction.

If the fuse releases again

and again, contact a quali-

fied electrician.

Replace the lamp.

Touch

and

at the

same time to activate the

display again.

Put the plug of the core tem-

perature sensor as far as

possible into the socket.