Garmin GPSMAP 6208 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Garmin GPSMAP 6208에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 6208 21 페이지. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Garmin GPSMAP 6208에 대해서도 마찬가지입니다: 소유자 매뉴얼 (2 페이지), 기술 참조 (42 페이지), 적합성 선언 (6 페이지), 템플릿 매뉴얼 (2 페이지), 보충 설명서 (24 페이지), 보충 설명서 (24 페이지)

페이지 인쇄

70 mm M4×0.7

screw (×4)

13. R epeat steps 11–12 for each nut plate on the remaining three corners of the mounting surface.

14. I nstall the rubber gasket on the back of the chartplotter. The top and bottom sections

line up with the holes.

15. I f you will not have access to the back of the chartplotter after you mount it, connect

all necessary cables to the chartplotter before placing it into the cutout.

16. P lace the chartplotter into the cutout.

17. S ecure the chartplotter to the mounting surface using the included 70 mm M4 × 0.7

screws and 7 mm black nylon washers.

NotE: To prevent corrosion of the metal contacts, cover unused connectors

(page 17) with the attached weather caps.

18. I nstall the mounting covers by snapping them into place.

Mounting the GPS 17x Antenna

You can surface mount the GPS 17x antenna, attach it to a standard 1 in. OD pipe-threaded-pole marine mount (14 threads-per-inch—not

included), or install the antenna under fiberglass.

Select a suitable location for the GPS 17x antenna on your boat. To ensure the best reception, mount the GPS 17x antenna in a location that has

a clear, unobstructed view of the sky in all directions.

• Avoid mounting the GPS 17x antenna where it is shaded by the superstructure of the boat,

a radome antenna, or a mast.

• On a sailboat, avoid mounting the GPS 17x antenna high on the mast to prevent inaccurate

speed readings caused by excessive heeling.

• The GPS 17x antenna provides more-stable readings when located nearer to water level.

• Mount the GPS 17x antenna at least 3 ft. (1 m) away from (preferably above) the path

of any radar beam or a VHF radio antenna.

Temporarily secure the antenna in the preferred mounting location and test it for correct

operation. If you experience interference with other electronics, try a different location. After

you verify correct operation, permanently mount the antenna.

tools required (not included):

• Drill and drill bits

• Screwdrivers

• Marine sealant (optional)

Flush-mounting a GPSMAP 6000 or 7000 Series Chartplotter

60 mm M3×0.5

Rubber gasket

(4 pieces)

Mounting covers (×2)

EMI

GPS 17x Placement Considerations

GPSMAP 6000/7000 Series Installation Instructions

Nut plate (×4)

screw (×4)

Mounting surface

Better

Good

EMI (Electromagnetic Interference)

from engine components

Above - best

Below - OK

Radar

VHF Radio Antenna

Best

3 ft.

(1 m)