Garmin MSC 10 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Garmin MSC 10에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin MSC 10 14 페이지. Marine satellite compass

Performing Menu-Based Calibration

1 Select Settings > Communications > NMEA 2000 Setup > Device List.

2 Select the MSC 10 from the device list.

3 Select Review > Compass Cal. > Begin.

4 Follow the on-screen instructions until the compass calibration is complete.

5 Select Auto Heading Alignment > Begin.

6 Follow the on-screen instructions until the heading alignment is complete.

Disabling the Magnetic Heading Data

If you cannot mount the device in an ideal location for magnetic heading and GPS performance, you can disable

the magnetic heading data.

Perform a factory reset

After a factory reset, the device no longer outputs magnetic heading data, but it continues to output GPS

Course over Ground and GNSS-based heading.

Adjusting the Fine Heading Alignment

You can adjust the Fine Heading Alignment in conjunction with Auto Heading Alignment to fine-tune the

heading output (optional).

NOTE: Fine heading alignment must be completed under open skies to ensure proper calibration.

1 Select Settings > Communications > NMEA 2000 Setup > Device List.

2 Select the MSC 10 device.

3 Select Review > Compass Cal. > Fine Heading Alignment.

4 Using a landmark or a known good compass, determine the heading of your boat.

5 Adjust the heading until it matches your measurement.

6 Select Done.

(Compass Settings, page

10).