Garmin Colorado 400c 소유자 매뉴얼 - 페이지 34

{카테고리_이름} Garmin Colorado 400c에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Colorado 400c 40 페이지. Oregon series
Garmin Colorado 400c에 대해서도 마찬가지입니다: 소유자 매뉴얼 (48 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (48 페이지), 중요 안전 정보 (48 페이지), 소유자 매뉴얼 (26 페이지), (덴마크어) 매뉴얼 (48 페이지)

ppendIx

Alarms and Messages

The Fishfinder 400C uses an on-screen message system to alert you

to unit operating characteristics. When a message appears, press

SElECt to acknowledge the message and return to the screen you

were viewing.

battery Alarm—battery voltage has fallen below the value entered

in the Battery Alarm setup.

battery Voltage Is too High—too much input voltage; the unit

shuts off in 10 seconds. Decrease the input voltage to 35 Volts or

less.

boat Is Not Moving Fast Enough to Calibrate—the boat is not

moving fast enough for the speed wheel to provide a valid speed.

Can't Read Voltages that High, limited to top of Range—the

voltage value in the Battery Alarm setup is higher than the unit can

read.

Can't Read Voltages that low, limited to bottom of

Range—the voltage value in the Battery Alarm setup is lower than

the voltage where the unit automatically turns off.

Deep Water Alarm—the Deep Water Alarm depth has been

reached.

Drift Alarm—the depth has changed by the amount of the Drift

Alarm value.

Fish Alarm—an icon appears and a beep sounds (if enabled) when a

fish is detected. This alarm does not show a message banner.

Shallow Water Alarm—the Shallow Water Alarm depth has been

reached.

Simulating Operation—the unit is in Simulator Mode.

Sonar Failed, Unit Needs Repair—there is an internal problem

with the fishfinder. Contact your dealer or Garmin Product Support

to have the unit serviced.

transducer Disconnected, Sonar turned Off—there is not a

transducer attached, bad cable/transducer, or the transducer cable

was disconnected. If the transducer cable is removed while the unit

is on, reconnect and cycle power.

Water Speed Sensor Is Not Working—the speed sensor is not

detected. Check the connections.

Entering (leaving) target water temperature—the target water

temperature is 2° F (1.1° C) above or below the temperature

specified by the Water Temperature Alarm. These messages appear

when you enter or leave that zone.

Fishfinder 400C Owner's Manual