ALKOTA 210 사양 - 페이지 2
{카테고리_이름} ALKOTA 210에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. ALKOTA 210 19 페이지.
페이지 인쇄
SAFETY, INSTALLATION, AND OPERATION
MACHINE UNPACKING
ALL CLEANERS ARE CAREFULLY INSPECTED
AND CARTONED TO PROTECT AGAINST
SHIPPING DAMAGE. IF THERE IS DAMAGE OR
MISSING PARTS, THE TRANSPORTATION
COMPANY AGENT SHOULD MAKE A NOTATION
TO THAT EFFECT ON THE BILL. REFER TO THE
PARTS LIST IN THIS MANUAL AND ADVISE WHAT
PARTS ARE MISSING OR DAMAGED.
AVAILABLE, GIVE THE INVOICE NUMBER ON
ALL ORDER BILLS.
ENABLE NEEDED PARTS TO BE SHIPPED
QUICKLY.
THANK YOU for selecting our product. READ ALL
Installation, Operation, and Maintenance
instructions before operating the machine
NOTE: Refer to CLEANER MODEL for SERIAL
NUMBER location
NOTE: Dimensions are in in inches unless
otherwise noted
IMPORTANT SAFETY
INSTRUCTIONS
The safety alert symbol
safety information about hazards that can result
in personal injury.
A signal word (DANGER, WARNING, or
CAUTION) is used with the alert symbol to
indicate the likelihood and the potential severity
of injury. In addition, a hazard symbol may be
used to represent the type of hazard
DANGER
indicates a hazard which, if not
avoided, will result in death or serious
WARNING
not avoided, could result in death or serious
injury.
CAUTION
not avoided, might result in minor or
moderate injury.
CAUTION,
symbol, indicates a situation that could result
in damage to the equipment.
Supersedes 10-00 Z08-00443
SPACE HEATER
THIS PROCEDURE WILL
is used to identify
indicates a hazard which, if
indicates a hazard which, if
when used without the alert
1. Before operating this machine, read and
observe all safety, unpacking, and operating
instructions. Failure to comply with these
instructions could create a hazardous
situation.
2. The operator of this equipment should not
operate this equipment when fatigued or under
influence of alcohol or drugs.
IF
3. The operator of this equipment should be
thoroughly familiar with its operation and
controls.
4. All installations must conform to all applicable
local codes. Contact your electrician, plumber,
utility company or seller for details.
5. If a fuel leak is found, DO NOT OPERATE THE
MACHINE. Shut off the motor and repair.
6. Do not operate the machine if any mechanical
failure is noted or suspected.
7. Disconnect the power before performing any
maintenance or repair on this machine.
8. Before starting the heater, survey the area for
possible hazards and correct before proceeding.
DANGER
AND SURFACES may be produced.
9. During normal operation of this machine, hot
discharges and hot surfaces may be produced.
Avoid burns by being aware of these areas and
staying
immediately after equipment operation.
10. DO NOT DIRECT THE EXHAUST TOWARD
ANY COMBUSTIBLE OR HEAT SENSITIVE
SURFACE. KEEP AT LEAST 10 FEET AWAY.
11. DO NOT start the burner unless a good flow
injury.
of air is coming from the heater.
WARNING: OPEN FLAME
this machine in an area with
combustible materials. A suitable fire
extinguisher should be available in the
operating area.
2
GENERAL SAFETY
HOT DISCHARGES
clear
of
them
:
Do not operate
12-03-03 Z08-00443
during
and