Garmin Fishfinder 300C 빠른 시작 매뉴얼 - 페이지 19
{카테고리_이름} Garmin Fishfinder 300C에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fishfinder 300C 25 페이지. Garmin fish finder - fishfinder user manual
Garmin Fishfinder 300C에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (8 페이지), 중요 안전 정보 (48 페이지), 템플릿 (1 페이지), (스페인어) 빠른 시작 매뉴얼 (24 페이지)
페이지 인쇄
Can't Read Voltages That Low, Limited
to Bottom of Range—the battery-alarm
screen voltage value is lower than the
voltage at which the Fishfinder 300C
automatically turns off.
Deep-Water alarm—the deep-water alarm
depth
(Configure
>
> On) has been reached.
Drift alarm—the depth has changed by the
amount on the drift-alarm screen
>
alarms
>
Drift
> On).
Entering (Leaving) Target Water
Temperature—the target water temperature
is 2°F (1.1°C) above or below the water
temperature alarm
(Configure
Water Temp
> On). These messages appear
when you enter or leave that zone.
Fish alarm—an icon appears
and a beep sounds (if enabled) when a fish
is detected. This alarm does not show a
message banner.
Shallow-Water alarm—the shallow-water
alarm depth
(Configure
Shallow Water
> On) has been reached.
Fishfinder 300C Quick Start Manual
alarms
>
Deep Water
(Configure
>
alarms
(page
12)
alarms
>
>
Simulating Operation—the Fishfinder
300C is in simulator mode.
Sonar Disabled Due to High Voltage.
Please Check Unit Voltage—the Fishfinder
300C voltage is greater than 20 volts. Check
the battery voltage
Turn the Fishfinder 300C off and back on
again to restore the sonar.
Sonar Failed, Unit Needs Repair—there
is an internal problem with the Fishfinder
300C. Contact your dealer or Garmin
Product Support to have the Fishfinder 300C
serviced.
Transducer Disconnected, Sonar Turned
>
Off—the transducer or cable are not
attached or need repair. If the transducer
cable is removed while the Fishfinder 300C
is on, reconnect and cycle power.
Water Speed Sensor is Not Working—the
speed sensor is not detected. Check the
connections.
> Numbers).
(Configure