Garmin Fishfinder 400C 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Garmin Fishfinder 400C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fishfinder 400C 40 페이지. Flush mount kit instructions and template (multilingual)
Garmin Fishfinder 400C에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 중요 안전 정보 (48 페이지), 적합성 선언 (1 페이지), 설치 지침 매뉴얼 (28 페이지), 설치 지침 매뉴얼 (30 페이지), 소유자 매뉴얼 (21 페이지)

페이지 인쇄

400c

nstallIng the

IshFInder

Connecting to a NMEA device

You can connect the Fishfinder 400C to another piece of NMEA

compatible electronic equipment, such as a Garmin GPS (Global

Positioning System) device. If equipped with a capable transducer,

the Fishfinder 400C can send depth, temperature, and speed

information. Refer to the wiring diagrams on

the Fishfinder 400C to NMEA compatible devices.

To install the wiring harness to a GPS or other NMEA

device:

1. Follow the voltage source installation steps (see page 10).

For Garmin units, the ground (Black) wires serve as NMEA

ground and must be attached together or on the same

terminal. Refer to the wiring diagram of your GPS unit for

wire identification.

2. Connect the Blue (NMEA Out) wire from the Fishfinder 400C

to the NMEA In wire on the GPS/NMEA unit's wiring harness.

3. Turn on the Fishfinder 400C NMEA Output setting (page 23).

For Garmin GPS units, set the communications interface to

NMEA/NMEA, NMEA In/NMEA Out, or NMEA.

Interfacing with NMEA

The Fishfinder 400C allows for NMEA 0183, Version 3.01 output

with a compatible GPS or navigation device. You must set NMEA

Output On to send data

(page

page 11

for connecting

23).

The SDDBT, SDDPT, SDMTW, SDVHW, SDWPL sentences are

sent in NMEA 0183, Version 3.01 output from the Fishfinder 400C.

You can purchase complete information about National Marine

Electronics Association (NMEA) format and sentences from:

NMEA

Seven Riggs Avenue

Severna Park, MD 21146 USA

www.nmea.org

Installing the Fishfinder 400C to a Garmin CANet

The Fishfinder 400C is a CANet-compatible sonar device.

Using the CANet (if applicable) optimizes the performance of

CANet-compatible units, allowing sonar information from the

Fishfinder 400C to be shared with up to two CANet compatible

Garmin GPS units. A standard NMEA connection only allows

depth, temperature, and speed information to be sent to a single GPS

device, whereas a CANet connection provides full sonar readings,

including Ultrascroll

, so you can view and control the same

™

information on your compatible GPS unit(s) as you can on your

Fishfinder 400C.

NOtE: To use the Garmin CANet with your Fishfinder 400C,

you must obtain a CANet Kit. Contact your Garmin dealer, or

visit www.garmin.com.

Fishfinder 400C Owner's Manual