Garmin FUSION APOLLO MS-WB675 매뉴얼 - 페이지 35

{카테고리_이름} Garmin FUSION APOLLO MS-WB675에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin FUSION APOLLO MS-WB675 46 페이지. Marine entertainment system
Garmin FUSION APOLLO MS-WB675에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (19 페이지)

페이지 인쇄

Adjusting Additional Audio Settings for a Zone

1 Select

> SETTINGS.

2 Select the name of the stereo.

3 Select ZONE.

4 Select a zone.

5 Select one or more options:

• To limit the maximum volume output of this zone, select VOLUME LIMIT, and adjust the level.

• To adjust the right and left speaker balance of this zone, select BALANCE, and adjust the balance.

• To reduce the power output to the external amplifier associated with this zone, select EXT. AMP GAIN,

and adjust the gain level.

• To reduce the power output to the internal amplifier associated with this zone, select INT. AMP GAIN, and

adjust the gain level.

NOTE: This setting is available only for zones associated with an internal amplifier, typically zones 1 and

• To change the output of this zone from stereo to mono, select MONO.

NOTE: The mono setting is useful if a listening position is closer to one speaker than the other and

predominantly hear only that channel. The mono setting combines both channels in each speaker in the

zone.

Source Settings

Select

> SETTINGS, select the name of the stereo, select SOURCE, and select the name of the source you

want to configure.

NOTE: This menu contains system-wide source settings. Most sources also have source-specific settings. See

the sections of this manual for each source for more information about source-specific settings.

Not all options are available for every source on the stereo.

SOURCE ENABLED: Enables and disables the source on this stereo. You may want to disable sources that will

never be used on the stereo so they no longer appear on the source-selection screen.

GROUP ENABLED: Enables and disables the sharing of the source when connected to other stereos in a group

(Fusion PartyBus Networking,

because streaming over the Fusion PartyBus network introduces a small audio lag that is not desirable in

some situations.

SOURCE NAME: Changes the name of the source as it appears on this stereo. This also affects how the source

appears to other stereos in a group.

Network Settings

Select

> SETTINGS, select the name of the stereo, then select NETWORK.

DHCP CLIENT: Sets the device as a DHCP client. This is the default setting for all devices that are not

configured to be a DHCP server.

STATIC IP: Allows you to set a static IP address for the device

GARMIN MARINE NETWORK: Allows the device to be used on a Garmin Marine Network so it can be viewed and

controlled by connected Garmin chartplotters

page 30).

DETAILS: Shows information about the network configuration.

ADVANCED: Allows you to configure the DHCP server and reset all network settings for this stereo to the factory

default values.

SAVE: Allows you to save changes to the network settings.

General Settings

page 22). You may want to disable sharing for some sources, such as AM,

(Configuring the Stereo for use with a Garmin Marine Network,

(Setting a Static IP Address,

page 30).