AEG F45078I-M 사용자 설명서 - 페이지 11
{카테고리_이름} AEG F45078I-M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG F45078I-M 35 페이지. 18” fully integrated dish washer
AEG F45078I-M에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 일반 매뉴얼 (43 페이지)
INSTALLATION INSTRUCTIONS
5
INSTALLATION AND HOOK-UP
DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF ON THE
SHARP EDGES OF THE APPLIANCE.
Remove the polystyrene rack blocks. Position the appliance in the chosen instal-
lation position. The sides and rear of the appliance can lie against kitchen units or
walls. If the dishwasher is installed next to a heat source, separate it with a heat
insulating panel in order to prevent overheating and malfunctions. To assure sta-
bility, only install built-in appliances under continuous worktops, securing them
to the adjacent kitchen units or worktop with screws.
BUILDING-IN A DISHWASHER UNDERNEATH A CERAMIC HOB IS ABSO-
LUTELY FORBIDDEN. A DISHWASHER CAN BE BUILT-IN UNDERNEATH
A CONVENTIONAL HOB PROVIDED THERE IS NO BREAK IN THE KITCH-
EN WORKTOP, AND THE DISHWASHER AND HOB ARE INSTALLED AND
SECURED CORRECTLY, SO THAT NO HAZARDS ARE GENERATED.
MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY INSTALLED
AND GROUNDED BY A QUALIFIED FITTER. THIS SAFETY REQUIRE-
MENT MUST BE MET. IN CASE OF DOUBT, CALL IN A QUALIFIED FIT-
TER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAIL-
URE TO GROUND THE APPLIANCE OR FROM A DEFECTIVE GROUND
CONNECTION .
BEFORE PROCEEDING WITH INSTALLATION, DISCONNECT THE
MAINS POWER SUPPLY FROM THE WORK AREA.
Only for free-standing models
•
It is strictly forbidden to mount a hob over a free-standing dishwasher.
•
If the appliance is not in a niche and can therefore be accessed on one side,
cover the door hinge area for safety reasons (cutting hazard). Covers are avail-
able as accessories from specialized retailers or from the Technical Service Cen-
tre.
•
To build in the dishwasher, purchase the
or from the Technical Service Centre.
Rev 0.0
relative kit from specialized retailers
EN
13