Garmin GHP 10 설치 지침 매뉴얼 - 페이지 38

{카테고리_이름} Garmin GHP 10에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GHP 10 48 페이지. Autopilot system, addendum
Garmin GHP 10에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (26 페이지), 소유자 매뉴얼 (28 페이지), 적합성 선언 (1 페이지), 참조 (1 페이지), 구성 참고 사항 (14 페이지)

페이지 인쇄

Advanced Configuration Power-on Procedure

Advanced configuration options are not available on the GHC 10 under normal conditions. To access the advanced configuration

settings of the GHP 10, use the advanced configuration power-on procedure.

To access the wizards and advanced configuration options:

1. With the power off, press both the center and the right soft keys on the GHC 10.

2. While pressing the center and the right soft keys, power the GHC 10 on.

3. Press all 3 buttons until the heading screen appears. Release the buttons.

To make sure the wizards and advanced configuration options are available:

1. From the heading screen, select

2. If the option for

Dealer Autopilot Configuration

advanced configuration power-on procedure.

Manually Running the Dockside and Sea trial Wizards

The Dockside Wizard and the Sea Trial Wizard allow you to quickly define all of the important configuration settings on the GHP 10.

If, after running the wizards, you do not feel as though the GHP 10 is working correctly, you can run the wizards again at any time. To

access the wizards, power the GHC 10 on using the advanced configuration power-on procedure.

to manually run the Dockside Wizard:

1. From the Heading screen, select

2. Perform the steps as prompted. For more information, see

to manually run the Sea trial Wizard:

1. From the Heading screen, select

2. Perform the steps as prompted. For more information, see

Changing Advanced Configuration Settings

You can run the Autotune automated configuration process, calibrate the compass, and define north on the GHP 10 through the

GHC 10 without running the wizards. Additionally, without running the wizards, you can individually define each configuration

setting. To access the automated configuration settings and the advanced configuration settings, power the GHC 10 on using the

advanced configuration power-on procedure

To manually run the automated configuration settings:

1. From the Heading screen, select

2. Select Autotune,

Calibrate

3. Perform the steps as prompted. For more information on each automated configuration setting, see

To manually define individual configuration settings:

1. From the Heading screen, select

2. Select the appropriate category of setting you want to configure.

3. Select the setting you want to configure. Refer to the description of each setting on

> Setup.

is available, you correctly performed the

Setup

Dealer Autopilot Configuration

Setup

Dealer Autopilot Configuration

Setup

Dealer Autopilot Configuration

Compass, or

Set

north.

Setup

Dealer Autopilot

page 35.

Configuration.

page

GHP 10 Marine Autopilot System Installation Instructions

Hold these

soft keys

Advanced Configuration

Power-on Procedure

Wizards

Dockside

Wizard.

Wizards

Sea trial

Wizard.

Automated

Setup.

page 35.

39.

and power the

GHC 10 on