Garmin GHP 10V 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Garmin GHP 10V에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GHP 10V 20 페이지. Marine autopilot system
Garmin GHP 10V에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (48 페이지), 소유자 매뉴얼 (28 페이지), 설치 지침 매뉴얼 (20 페이지)
페이지 인쇄
GHC 10 Power/Data Cable
Use this cable (packaged with the GHC 10) to connect the GHC 10 to power, to the CCU, and to an optional NMEA 0183-compatible GPS
device (if you do not have a NMEA 2000-compatible GPS device on the NMEA 2000 network).
(Garmin replacement part number: 010-11074-00)
Alarm
Wire the included alarm to the CCU using the CCU cable. The alarm provides
audible alerts from the GHP 10V.
(Garmin replacement part number: 010-11056-00)
NMEA 2000 Cables and Connectors
The NMEA 2000 cables connect the CCU and the GHC 10 to the NMEA 2000 network. Use the NMEA 2000 power cable and two terminators
to create a NMEA 2000 network on your boat if one does not exist. Additional NMEA 2000 cables and connectors are available, if necessary.
You can use a NMEA 2000 drop cable to extend the CCU cable, if necessary.
For more information on NMEA 2000, see
NMEA 2000 drop cable, 6
/
ft. (2 m) (two included)
1
2
Garmin replacement part number: 010-11076-00
NMEA 2000 power cable (one included)
Garmin replacement part number: 010-11079-00
Tools
•
Safety glasses
•
Drill and drill bits
•
3
/
in. (90 mm) hole saw
17
32
•
Scissors
•
Wire cutters/strippers
•
File and sandpaper
•
Phillips screwdriver and flat screwdriver
•
Cable ties
note: Mounting screws are provided for the GHC 10 and for the CCU. If the provided screws are not appropriate for the mounting surface, you will
need to provide the correct types of screws.
GHP 10V Installation Instructions
page
9.
•
•
•
•
•
•
NMEA 2000 T-connector (three included)
Garmin replacement part number: 010-11078-00
NMEA 2000 terminators (one of each included)
Garmin replacement part number (male):
010-11080-00;
Garmin replacement part number (female):
010-11081-00
Waterproof wire connectors
Compass (to test for magnetic interference when finding a
suitable location for the CCU)
Surface-specific mounting hardware (screws or bolts)
Marine sealant
Anti-seize lubricant (optional)
Additional NMEA 2000 cables and connectors (optional)