Garmin Gladiator TR-1 설치 및 사용자 설명서 - 페이지 3
{카테고리_이름} Garmin Gladiator TR-1에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Gladiator TR-1 4 페이지. Garmin tr-1 marine autopilot: user guide
Garmin Gladiator TR-1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지), 소유자 매뉴얼 (36 페이지)
페이지 인쇄
The Integrator unit is mounted on any fl at surface, using two #6 screws provided, through the mounting holes
in the case. The unit should be located so its LED is visible to the helmsman during normal boat operation, but
not directly in the line of vision due to the brightness of the LED. Although the Integrator is a completely sealed
unit it should be mounted in a location that is not subject to immersion or water from wash down.
Installation of The Integrator consists of mounting the device in a suitable location, connecting wiring for
NMEA input and AD10 output signals, and providing a switched 12 volt power supply and ground.
NMEA Out
Gladiator
Compass
Ball
Connector
Power
NMEA 0183
AD10
The radar or plotter should be confi gured for magnetic oriented AD10 data when using the TR-1 Gladiator as
the heading data source. As setup procedures are unit specifi c, please refer to the operator's manual of your
Radar/Charplotter, for proper confi guration procedure.
Mounting Considerations
Red ( + )
Red ( + )
{
Black ( - )
Black ( - )
Integrator
Wire Color
Orange AD10 Clock +
Green Ad 10 Clock - _
Blue AD 10 Data +
Brown AD 10 Data -
Wire Color
Signal
Red
+ 12 VDC
Black
Ground
Red
NMEA +
Black
NMEA -
Orange
AD10 Clock +
Green
AD 10 Clock -
Blue
AD10 Data +
Brown
AD 10 Data -
Radar/Chartplotter MARPA Confi guration
Installation
Connects To
Furuno Clock + (Yellow)
Furuno Clock - (Green)
Furuno Data + (White)
Furuno Data - (Black)
Connects To
Switched Power Source
Engine Ground
Gladiator NMEA Out + (Red)
Gladiator NMEA Out - (Black)
Furuno Clock + (Yellow)
Furuno Clock - (Green)
Furuno Data + (White)
Furuno Data - (Black)
Page 3
Red ( + )
Switched
Black ( - )
12 V Pwr
Source