Garmin Gladiator TR-1 소유자 매뉴얼 - 페이지 33

{카테고리_이름} Garmin Gladiator TR-1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Gladiator TR-1 36 페이지. Garmin tr-1 marine autopilot: user guide
Garmin Gladiator TR-1에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (4 페이지), 소유자 매뉴얼 (13 페이지)

페이지 인쇄

The Autopilot does not need to connect to a GPS for the autopilot to work, but if you want to use

waypoint steering you must connect to a GPS and set North see page 30. The Autopilot will accept

NMEA input from two GPS units and transmit NMEA to one receiving device. Only one of the GPS

inputs is used for steering control at a time. Selection of the controlling GPS is made through the

NMEA source selection [code 34] (see pages 19-22 for explanation of setup codes). The NMEA

output port transmits the NMEA sentence $APHDG at 4800 baud. The output refresh rate is selectable

via [code 49] from 0 to 10 Hz. The Autopilot requires the data sentences RMC and RMB to be on.

The NMEA conductors are in the cable stub at the base of the Compass Ball. (See Labels on Wires

for Identifi cation) The wire color codes and signal names are shown in the wiring diagram below.

You must calibrate the compass ball and set North during Sea Trial of autopilot for it to work

correctly.

Note: If you are using Radar Overlay, you may need to adjust code 168 in order for your overlay to

line up correctly.

See pages 38-41 in the installation manual or go to www.tr-1autopilots.com (Manuals)for updates

of specifi c brands of GPS wiring confi gurations. Not all GPS brands and models are available.

TR-1 updates these regularly. The chart is a guide only and is to help you with your GPS connections

Compass

Ball

Blue Connectors (for connecting wires from the Shadow Drive, Warning Horn and GPS)

Fig. 20

Twist wires together. (Fig 20) Slide the blue connectors over the wires (Fig 21) and

crimp using pliers as in Fig 22. Be careful not to smash the connectors too hard, it

will cut the wires.

NMEA 0183 Connections

Wire Connectors

Red ( +)

{

NMEA Out

Black (- )

Yellow ( + )

{

NMEA In # 1

White ( - )

Blue ( + )

{

NMEA In # 2

Brown ( - )

Green (GND)

and should not be used as factual

information. Please check your GPS

( + )

Chart Plotter

}

( - )

Radar Overlay

manual for verifi cation of NMEA 0183

NMEA IN*

( + )

connections on your application. This

}

GPS #1

( - )

NMEA out*

is not a compatibility chart, but most all

( + )

GPS #2

}

GPS units are compatible with the

( - )

NMEA

out*

TR-1 Gladiator.

Not normally

Used

Note: For non-compliant NMEA

0183 devices, please read page 33

Fig. 21

Fig. 22