AEG F55412VI0 사용자 설명서 - 페이지 17

{카테고리_이름} AEG F55412VI0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG F55412VI0 20 페이지.
AEG F55412VI0에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지)

페이지 인쇄

• If you regularly use short duration

programmes, these can leave

deposits of grease and limescale

inside the appliance. To prevent this,

12. TROUBLESHOOTING

If the appliance does not start or it stops

during operation. Before you contact an

Authorised Service Centre, check if you

can solve the problem by yourself with

the help of the information in the table.

Problem and alarm code

You cannot activate the ap-

pliance.

The programme does not

start.

The appliance does not fill

with water.

The display shows

The appliance does not

drain the water.

The display shows

The anti-flood device is on.

The display shows

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.

Possible solution

• Make sure that the mains plug is connected to the

mains socket.

• Make sure that there is no a damage fuse in the fuse

box.

• Make sure that the appliance door is closed.

• Press Start.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge

the resin inside the water softener. The duration of the

procedure is approximately 5 minutes.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Close the water tap and contact an Authorised Service

Centre.

we recommend to run long duration

programmes at least 2 times per

month.

With some problems, the display

shows an alarm code.

For alarm codes not described in the

table, contact an Authorised Service

Centre.

ENGLISH