AEG FAVORIT 34030 VI 사용자 설명서 - 페이지 19
{카테고리_이름} AEG FAVORIT 34030 VI에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 34030 VI 20 페이지. Dishwasher
AEG FAVORIT 34030 VI에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 사용자 설명서 (20 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
Problem
Whitish streaks and
stains or bluish lay-
ers on glasses and
dishes.
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Possible cause
The set level of the water
softener is incorrect.
The cap of the salt contain-
er is loose.
The released quantity of
rinse aid is too much.
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
The programme had no
drying phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
Possible solution
Make sure that the set level
of the water softener agrees
with the water hardness in
your area.
Tighten the cap.
Decrease the released quan-
tity of rinse aid .
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
Set a programme with the
drying phase.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
596 / 818-898 / 555
(0.5 / 0.05 ) / (8 / 0.8 )
2)
ENGLISH
19
220-240 V
50 Hz
max. 60 °C
12
1.90 W
0.10 W