AEG FAVORIT 3A 사용자 지침 - 페이지 27

{카테고리_이름} AEG FAVORIT 3A에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 3A 44 페이지. Aeg dishwasher
AEG FAVORIT 3A에 대해서도 마찬가지입니다: 사용자 지침 (40 페이지), 사용자 지침 (48 페이지)

페이지 인쇄

1. Open the door of the dishwasher. The wash programme stops.

2. The indicator for the programme that is currently running extinguishes.

3. Close the door. The wash programme continues.

Cancelling the wash programme

1. Press the button for the current wash programme and hold it pressed.

The programme indicator for the current wash programme flashes for a

few seconds and then extinguishes.

2. Release the programme button, the wash programme is cancelled.

A selected programme is only interrupted by switching off the dish-

washer, it is not cancelled. The wash programme is continued when the

dishwasher is switched on again.

Setting or Changing the Delay Start Timer

Using the delay start timer you can delay.

Setting the delay start timer:

1. Press the ON/OFF button.

2. Keep pressing the DELAY TIMER button b until the number of hours of

delay is flashing on the multi-display.

3. Press the button for the desired wash programme. The multi-display

now displays the number of hours without flashing. The number of

hours is saved.

4. The wash programme starts automatically at the end of the delay set.

Changing the delay start:

As long as the wash programme has not started, you can still change

the delay start set by pressing the DELAY TIMER button b.

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes

in the upper and/or lower rack, an intelligent electronic system adjusts

the amount of water and the duration of the wash programme to the

number of dishes. By this means it is possible to wash only a few dishes

quickly and economically. At half load (6 place settings), up to 2 litres

of water and 0.2 kWh of electricity are saved.

Operating Instructions