AEG FAVORIT 40360 I 사용자 지침 - 페이지 35

{카테고리_이름} AEG FAVORIT 40360 I에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 40360 I 40 페이지. Aeg dishwasher user manual

Leak Prevention System

For protection from damage due to water leaks, the dishwasher is

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

In the event of a fault, the safety valve in the appliance immediately

interrupts the inflow of water and the drain pump is activated. By this

means water can neither escape nor overflow. The remaining water in

the appliance is automatically pumped out.

The leak prevention system also works when the appliance is switched

off.

In compliance with electric company technical requirements for mains

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations

and, if applicable, any additional conditions required by your local elec-

tricity supplier. Following installation, live parts and live insulated wir-

ing must not be accessible using a finger test in accordance with EN

60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating

plate on the right side of the inner edge of the dishwasher door. If the

appliance has a change-over switch, the additional instructions on the

change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at

the site of installation match the nominal voltage and current rating

given on the rating plate. The required fuse protection is also to be

found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug.

Important: The plug must still be accessible after the appliance has

been installed.

If the appliance is hard-wired to the mains supply, then it must be

safely isolated from the mains within the electrical installation with

switches intended to ensure all-pole(N,L1) disconnection, shall be

directly connected to the supply terminals and shall have a contact

separation (fuses, cut outs, current trips or similar) of at least 3mm in

each pole.

Installation and Connection Instructions