AEG FAVORIT 40760 사용자 정보 - 페이지 30

{카테고리_이름} AEG FAVORIT 40760에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 40760 48 페이지. Aeg dishwasher favorit 60860

페이지 인쇄

What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display dur-

ing operation:

– Fault codeÅ 10 (Problems with water inlet),

– Fault codeÅ 20 (Problems with water drainage),

please have a look at the following table.

When the fault is remedied, press the button for the cycle that has

started. The cycle will continue.

With other fault codes ("Å " followed by a number):

– Abort the dishwashing cycle.

– Switch the appliance off and on again.

– Re-set the dishwashing cycle.

If the fault is displayed again, please contact the Customer Care De-

partment and inform them of the fault code.

Malfunction

The cycle indicator for the

selected dishwashing cycle

is flashing:

the control indicator WA-

TER is lit,

fault code

played in the multi-display

(Problems with water inlet).

The cycle indicator for the

selected dishwashing cycle

is flashing,

fault code

played in the multi-display

(there is water in the dish-

washer's internal dispenser).

Fault code

played in the multi-display.

Water tap is blocked with

limescale or faulty.

The tap is turned off.

The filter (where present)

in the threaded hose fit-

ting on the tap is blocked.

Filters in the base of the

Å 10

is dis-

washing compartment are

blocked.

Water inflow hose

has not been correctly po-

sitioned.

The sink outlet is blocked. Clean out sink outlet.

Water drain hose

Å 20

is dis-

has not been correctly po-

sitioned.

Å 30

is dis-

The anti-flood system has

been triggered.

Possible cause

Remedy

Check the water tap and

have it repaired if necessary.

Turn the tap on.

Clean the filter in the

threaded hose fitting.

Cancel the dishwashing cy-

cle (see chapter: Starting a

dishwashing cycle),

clean filters (see chapter:

Cleaning the filters),

then start the dishwashing

cycle again.

Check the position of the

hose.

Check the position of the

hose.

First shut off the water tap,

then switch off the appli-

ance and contact the Cus-

tomer Care Department.