Garmin NMEA 2000 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Garmin NMEA 2000에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin NMEA 2000 10 페이지. Technical reference for garmin nmea 2000 products
Garmin NMEA 2000에 대해서도 마찬가지입니다: 데이터시트 (1 페이지), 기술 참조 (30 페이지), 기술 참조 (42 페이지), 사용 설명서 (20 페이지), 설치 지침 매뉴얼 (40 페이지), 참조 (42 페이지), 기술 참조 (20 페이지)

페이지 인쇄

To mount the GXM 51 with the cable routed through the pole:

1. Position a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch—not

included) in the preferred location, and mark the approximate center of the pole.

2. Drill a hole using a

3. Fasten the pipe-threaded pole marine mount to the boat.

4. Thread the pole-mount adapter onto the pole. Do not overtighten the adapter.

5. Route the NMEA 2000/audio cable through the pole and connect it to the GXM 51 antenna.

6. Place the GXM 51 antenna on the pole-mount adapter

place

➋

7. Secure the antenna to the adapter with the included M3 set screw

8. (Optional) With the GXM 51 installed on the pole mount, fill the vertical cable slot with a

marine sealant (not included).

9. Route the NMEA 2000/audio cable away from sources of electronic interference, and

connect it to your NMEA 2000 network and to the audio input of your stereo receiver

(see

page

5).

Under-deck-mounting the GXM 51 Antenna

The GXM 51 can be mounted under a fiberglass surface with the adhesive pads attached to the

under-deck mounting bracket. The GXM 51 will not acquire satellite signals through metal—

you can only use the under-deck mount under a fiberglass surface.

1. Determine the location on the

fiberglass surface where you

want to mount the GXM 51.

2. Place the adhesive pads on

the under-deck mounting

bracket.

3. Place the GXM 51 in the

under-deck mounting bracket.

4. Adhere the under-deck

mounting bracket to the

mounting surface.

5. Secure the under-deck mount

to the mounting surface with

screws. Use extreme care to ensure that the screws do not penetrate the upper surface of

the deck.

6. Connect the NMEA 2000/audio cable to the GXM 51.

7. Route the NMEA 2000/audio cable away from sources of electronic interference, and

connect it to your NMEA 2000 network and to the audio input of your stereo receiver (see

step 3 below).

in. (19 mm) drill bit for the cable to pass through.

Adhesive

pads

Mounting

surface

➊

and twist it clockwise to lock it in

GXM 51

antenna

Under-deck

mounting bracket

➌

GXM 51 Installation Instructions