Garmin NMEA 2000 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Garmin NMEA 2000에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin NMEA 2000 40 페이지. Technical reference for garmin nmea 2000 products
Garmin NMEA 2000에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (10 페이지), 데이터시트 (1 페이지), 기술 참조 (30 페이지), 기술 참조 (42 페이지), 사용 설명서 (20 페이지), 참조 (42 페이지), 기술 참조 (20 페이지)

페이지 인쇄

Adapter cable

Wiring

connections

NMEA 2000 Transducer Adapter Kit installation Layout

Mounting the NMEA 2000 Transducer Adapter Kit

After you have determined a suitable location to install the NMEA 2000 Transducer Adapter,

use the included mounting bracket to mount it to the bulkhead or other suitable structure.

1. Using the mounting bracket as a template, mark the four pilot-hole locations.

2. Using a

in (2.5 mm) drill bit, drill the four pilot holes.

3. Place the adapter in the bracket and secure the mounting bracket to the mounting surface

using the included 10 mm M3 screws.

Wiring the NMEA 2000 Transducer Adapter Kit to the

installed Transducer

Use the included adapter cable to wire the NMEA 2000 Transducer Adapter Kit to the installed

transducer.

To wire the adapter cable to the installed transducer:

1. Disconnect the installed transducer from the installed display device.

2. Cut the three wires from the installed transducer to the same length. Do not strip the wire

insulation. If the installed transducer has more than the three wires indicated in the wiring

assignment table, cut and tape the additional wires.

3. Use the included water-resistant connectors to connect the wires from the installed

transducer to the wires on the included adapter cable, according to the wiring assignment

table. (See

page

NoTE: Some installed transducers may have a purple wire instead of a blue wire. If your

transducer has a purple wire, connect it to the blue wire on the adapter cable.

Cable tie-down

Adapter Cable

Black

Blue

Green

Wiring Assignment Table

NMEA 2000

drop cable

NMEA 2000

transducer adapter

Mounting

bracket

point

Installed

transducer

installed Transducer

Black

Blue or purple

Bare wire

NMEA 2000 Transducer Adapter Kit Installation Instructions

To the

existing

NMEA 2000

network