Garmin NMEA 2000 참조 - 페이지 39

{카테고리_이름} Garmin NMEA 2000에 대한 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin NMEA 2000 42 페이지. Technical reference for garmin nmea 2000 products
Garmin NMEA 2000에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (10 페이지), 데이터시트 (1 페이지), 기술 참조 (30 페이지), 기술 참조 (42 페이지), 사용 설명서 (20 페이지), 설치 지침 매뉴얼 (40 페이지), 기술 참조 (20 페이지)

페이지 인쇄

Location

TEMPSOURCE Value

Water

Air outside

Air inside

Engine room

Main cabin

To configure the temperature offset if the menu option is not displayed:

If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same as temperature data displayed on other devices,

you can configure the temperature offset to increase or decrease the displayed temperature by a specific amount.

1. From the NMEA 2000 Devices list, select the GST 10 device.

2. Select an option:

• For most Garmin chartplotters, select

• For other Garmin marine devices, select

3. Enter the following command: "TEMPOFFSET="

4. After the command, enter a positive or negative decimal number, followed by Done.

For example, TEMPOFFSET=-2.5Done indicates that the temperature readings displayed on the gauge connected to the GST 10 adapter

will be decreased by 2.5 degrees Celsius.

To configure the sensor number if the menu option is not displayed:

If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source, each adapter is assigned a unique sensor number

automatically. If the "Invalid NMEA 2000 temperature configuration" error message appears, you must assign a unique sensor number to each

adapter.

For example, if two adapters are assigned the NMEA 2000 temperature source value of Live Well and the error message appears, you must

assign each adapter a unique number.

1. From the NMEA 2000 Devices list, select one of the GST 10 devices assigned to the same temperature source.

2. Select an option:

• For most Garmin chartplotters, select

• For other Garmin marine devices, select

3. Enter the following command: "INSTANCE="

4. After the command, enter a positive decimal number, followed by Done.

5. Repeat steps 1–4 for each GST 10 device assigned to the same temperature source.

For example, if two GST 10 adapters are assigned the value of Live Well, assigning INSTANCE=1 to the first adapter and assigning

INSTANCE=2 to the second adapter prevents the error message.

Restoring Factory Default Settings

You will lose all custom configuration settings when you restore factory default settings.

1. From the NMEA 2000 Devices list, select the GST 10 device.

2. Select an option:

• For most Garmin chartplotters, select

• For other Garmin marine devices, select

3. Select Yes.

Technical Reference for Garmin NMEA 2000 Products

Location

Live well

Bait well

Refrigeration

Heating system

Freezer

Review

Generic

Config >Generic

Review

Generic

Config >Generic

Review

Factory

Config

Factory

TEMPSOURCE Value

Config.

Configuration.

Config.

Configuration.

Defaults.

NMEA 2000 Checklist